Fostex LR16 Punch in/out using a footswitch, At the punch out point, press only the Play key

Model LR16 [Recorder functions / Recording/playback]

(7)At the punch in point, press the [RECORD] key while holding down the [PLAY] key.

Track 3 is punched in (switches from playback to recording).

<Note>: To perform punch in, do not for- get to hold down the [PLAY] key when pressing the [RECORD] key.

(8)At the punch out point, press only the [PLAY] key.

Track 3 is punched out (switches from recording to playback).

<Note>: You cannot perform punch in/ out successively without stopping the re- corder. To perform more than one punch in/out operation, stop the recorder each time you finish punch in/out.

(9)Press the [STOP] key to stop the recorder, and locate the recorder back to the punch in position.

<Memo>: By pressing the [STOP] key on the mixer section, the recorder automati- cally skips to the beginning of the project (ABS 0) and stops.

(10)Press the [PLAY] key to play back the project to check the result.

If you are not satisfied with the result, roll back the previous project data before punch in/out (see page 76 for details).

Punch in/out using a footswitch

You can perform punch in/out using a footswitch connected to the [FOOT SW] jack on the rear panel of the main unit.

The following procedure example describes how to perform punch in/out to track 3 of the project whose tracks 1 through 8 have been recorded. It is assumed that you have completed source connection, level adjustment, mixer settings, etc.

<Note>: To use a footswitch for punch in/out, the "Foot SW" item in the "System" menu of the MENU mode must be set to "P I/O". Though it is set to "P I/O" by default, if it is set to an option other than "P I/O", change it to "P I/O" (see page 77 for details).

INPUT

P (+4dBu) EFF SEND (-2dBu) AUX SEND (-2dBu) INSERT INSERT INSERT INSERT INSERT INSERT I

ST MIX OUT (-10dBV) USB MIDI OUT FOOT SW CONTROLLER PANEL LOCK

PHANTOM POWER

	Footswitch
Press down the	Press down the footswitch again
footswitch (punch in).	(punch out).

Playback Recording Playback

(1)Connect an unlatched footswitch to the [FOOT SW] jack.

<Note>: Do not use a footswitch which is not the unlatched type. Connecting an improper footswitch may cause malfunc- tion.

(2)Turn off the [NEW PROJECT] key in the recorder section.

(3)Turn on the [REC TRACK SELECT] key for track 3.

(4)Set the [SOURCE] switches on mixer channels 1 through 8 to "TRK" ().

The playback signals of tracks 1 through 8 are routed to the mixer input channels.

55