Agilent Technologies E2251A user manual Module Field Wiring Information

Page 23

M-Module Field Wiring Information

The following section provides a brief, summary of the field wiring for each Hewlett-Packard M-module. It includes a connector pin-out table, a simplified schematic, and a connector drawing. For additional information about a specific M-Module, refer to the respective M-Module’s User’s Manual.

Caution Do not exceed the voltage and current specifications for the individual modules.

Caution All installation, wiring, and configuration procedures are to be done with power DISCONNECTED from the VXI mainframe and power DISCONNECTED from any external wiring/cabling.

WARNING To prevent electric shock, tighten all faceplate and mounting screws when installing M-Modules on the Carrier and the field wiring connector mounting screws.

Assembling the M-Module Field Wiring Connector

Most M-Modules come supplied with a 44-pin connector and matching hood with strain relief (kit part number E2251-01203). You must supply your own cable. The figure on the next page shows how to assemble the connector and hood.

Note

Do not assemble the hood to the connector for the two internally-mounted M-Modules. Strain

 

relief can be provided by wire ties through holes in the Carrier.

 

 

21

Page 22 Page 24
Image 23
Page 22 Page 24
Contents E2251-90002 Page Contents Contents Agilent Technologies Warranty Statement Documentation History Page Declaration of Conformity Page Page Module Installation Remove the Carrier Shields Determine M-Module Layout Guidelines for Determining Logical Addresses Set the Logical Address for each M-ModuleModule M3 Module M2 Module M1 Install M-Modules onto the Carrier Connect Field Wiring to Slot M4 & M5 M-Modules Reattach the Carrier Shields Install Carrier into C-Size VXI Mainframe Connect Field Wiring to Front M-Modules Installation / Operational Verification Removing M-Modules from the Carrier Assembling the M-Module Field Wiring Connector Module Field Wiring InformationPage Place connector Connector screws on bottom shell E2259A Double-Wide Breadboard M-Module Wiring Information E2259A J102 Pinout Table Serial Port 1 Serial Port Serial Port 3 Serial Port E2261A Quad RS-232 Interface Wiring InformationPage E2270A 16-Channel Form a Switch Wiring Information ROW2LO E2271A 4x4 Matrix Switch Wiring InformationChannel Configuring the E2272A E2273A 8-Channel Form C Switch Wiring Information E2274A 4-Channel Power Relay Wiring Information Use E2290A 16-Bit Digital I/O Wiring InformationE2291A 16-Channel Isolated Digital Output Wiring Information Page Numerics IndexPosition in Carrier, 11 removing from Carrier, 20 slots
Top Page Image Contents