Agilent Technologies E2251A E2291A 16-Channel Isolated Digital Output Wiring Information

Page 37

E2291A 16-Channel Isolated Digital Output Wiring Information

Note: User must supply +5Vdc to the module. You can supply up to four isolated supplies (+5V1/TGND1, +5V2/TGND2, +5V3/TGND3, +5V4/TGND4) or they can be combined and one supply used. Refer to the drawing below.

CAUTION The maximum collector-emitter voltage is 36 VDC.

Image 37

Contents E2251-90002 Page Contents Contents Agilent Technologies Warranty Statement Documentation History Page Declaration of Conformity Page Page Module Installation Remove the Carrier Shields Determine M-Module Layout Guidelines for Determining Logical Addresses Set the Logical Address for each M-ModuleModule M3 Module M2 Module M1 Install M-Modules onto the Carrier Connect Field Wiring to Slot M4 & M5 M-Modules Reattach the Carrier Shields Install Carrier into C-Size VXI Mainframe Connect Field Wiring to Front M-Modules Installation / Operational Verification Removing M-Modules from the Carrier Assembling the M-Module Field Wiring Connector Module Field Wiring InformationPage Place connector Connector screws on bottom shell E2259A Double-Wide Breadboard M-Module Wiring Information E2259A J102 Pinout Table Serial Port 1 Serial Port Serial Port 3 Serial Port E2261A Quad RS-232 Interface Wiring InformationPage E2270A 16-Channel Form a Switch Wiring Information ROW2LO E2271A 4x4 Matrix Switch Wiring InformationChannel Configuring the E2272A E2273A 8-Channel Form C Switch Wiring Information E2274A 4-Channel Power Relay Wiring Information Use E2290A 16-Bit Digital I/O Wiring InformationE2291A 16-Channel Isolated Digital Output Wiring Information Page Numerics IndexPosition in Carrier, 11 removing from Carrier, 20 slots