Monessen Hearth BWB400I, BWBC400I manual Part a

TRIM INSTALLATION

Wall ties should be fastened to the face of the fireplace with sheet metal screws and placed in the mortar joints of masonry trim.

FIGURE 31

COMBUSTIBLE FRAMING

MEMBERS FACING MATERIAL

TO TOP OF SPACERS.

PART A

NON-COMBUSTIBLE
FACING MATERIAL	USE ONLY NON-COMBUSTIBLE
	MATERIALS BELOW TOP OF SPACERS.

FIREPLACE FACE
	WARNING:
	THE SPACE BETWEEN THE
STEEL LINTEL	FACE OF THE FIREPLACE
(OPTIONAL)	AND THE NON-COMBUSTIBLE
	FACING MATERIAL MUST BE
CAUTION:	SEALED. FAILURE TO
DO NOT COVER	PROPERLY SEAL THIS CRACK
OR RESTRICT SIDE VENT	CAN CAUSE A POSSIBLE FIRE
AREAS WITH SURROUND	HAZARD AND WILL VOID THE
OR TRIM MATERIALS.	WARRANTY.

PART B

COMBUSTIBLE SURROUND MATERIALS MAY BE PLACED WITHIN SHADED AREAS. NOTE: COMBUSTIBLE MATERIALS MUST NOT OVERLAP BLACK PAINTED SURFACE MORE THAN 1/8".)

COMBUSTIBLE FRAMING MEMBERS TO TOP OF SPACERS

PART C

TOP SPACER

OUTLINE OF		FRAMING
		EXTEND LINE FROM OPPOSITE REAR OF
FIREPLACE
		FIREBOX THRU A POINT 4" IN FRONT OF
FIREBRICK
		FIREPLACE FACE, AND 1" OUTSIDE OF
	1/4"	SCREENED OPENING.
		FINISH WALL
4"	SCREENED OPENING
(REF.)
	OF FIREPLACE

12" MAX.

COMBUSTIBLE MANTEL

COMBUSTIBLE SURROUND TRIM

		**	: 12" MINIMUM FROM TOP OF FIREPLACE OPENING TO BOTTOM OF
	**		COMBUSTIBLE TRIM MATERIAL WHICH PROJECTS MORE THAN 1-1/2"
			BEYOND THE TOP OF THE FIREPLACE OPENING.
*		*	: 6" MINIMUM FROM TOP OF FIREPLACE OPENING TO BOTTOM OF
			COMBUSTIBLE TRIM MATERIAL WHICH PROJECTS NO MORE THAN
			1-1/2" BEYOND THE FACE OF THE FIREPLACE.

TOP OF FIREPLACE OPENING

INSTALLATION OF COMBUSTIBLE TRIM MATERIALS

ABOVE THE TOP OF THE FIREPLACE OPENING

PART C OF FIGURE 31 SHOWS ACCEPTABLE COMBUSTIBLE MANTEL LOCATION IF FIREPLACE IS INSTALLED TO BURN WOOD. SEE FIGURES 29 AND 30 FOR ACCEPTABLE COMBUSTIBLE MANTEL LOCATIONS IF AN UNVENTED GAS APPLIANCE IS INSTALLED IN THE FIREPLACE. PARTS A AND B OF FIGURE 31 ARE TYPICAL FOR EITHER WOOD OR UNVENTED GAS APPLIANCE INSTALLATION.

27

53D9031. Rev 1 03/03