TRIM INSTALLATION
INSTALLATION OF
COMBUSTIBLE FRAMING
MEMBERS FACING MATERIAL
TO TOP OF SPACERS.
FIGURE 29
FACING MATERIAL USE ONLY
FIREPLACE FACE |
|
| WARNING: |
| THE SPACE BETWEEN THE |
STEEL LINTEL | FACE OF THE FIREPLACE |
(OPTIONAL) | AND THE |
| FACING MATERIAL MUST BE |
CAUTION: | SEALED. FAILURE TO |
DO NOT COVER | PROPERLY SEAL THIS CRACK |
OR RESTRICT SIDE VENT | CAN CAUSE A POSSIBLE FIRE |
AREAS WITH SURROUND | HAZARD AND WILL VOID THE |
OR TRIM MATERIALS. | WARRANTY. |
INSTALLATION OF COMBUSTIBLE DECORATIVE TRIM AND THE FIREPLACE SURROUND
COMBUSTIBLE FRAMING MEMBERS
FACING MATERIAL TO TOP OF SPACERS.
FIGURE 30
USE ONLY
MATERIALS BELOW TOP
OF SPACERS.
1" AIR SPACE TO SIDES AND REAR OF FIREBOX 
IT IS RECOMMENDED THAT YOU
INSULATE OUTER AND INNER WALLS
OF CHASE. ALWAYS MAINTAIN THE
PROPER CLEARANCE.
OUTSIDE AIR INLET
SAFETY STRIP
12" MAXIMUM
COMBUSTIBLE MANTEL
TOP EDGE OF FIREPLACE
18" MINIMUM FROM FIREPLACE OPENING TO BOTTTOM OF COMBUSTIBLE MANTEL, (MANUFACTURER RECOMMENDATION).
SEE NOTE BELOW REGARDING H2853 CANOPY.
TOP EDGE OF FIREPLACE OPENING
HEARTH EXTENSION
NOTE:
WHEN AN APPROVED ANSI Z21.11.2 UNVENTED ROOM HEATER IS INSTALLED IN THIS FIREPLACE, AN H2853 CANOPY MUST ALSO BE INSTALLED.
FIGURE 31
COMBUSTIBLE SURROUND MATERIALS MAY BE PLACED WITHIN SHADED AREAS. (NOTE: COMBUSTIBLE MATERIALS MUST NOT OVERLAP BLACK PAINTED SURFACE.)
OUTLINE OF
FIREPLACE
FIREBRICK
4"
(REF.)
FRAMING
EXTEND LINE FROM OPPOSITE REAR OF
FIREBOX THRU A POINT 4" IN FRONT OF
FIREPLACE FACE, AND 1" OUTSIDE OF
1/4" SCREENED OPENING.
FINISHED WALL
SCREENED OPENING
OF FIREPLACE
27
53D9032. Rev 1 03/03