10. INSTALLATION OF LOG SET and EMBERS
A. INSTALLING THE GLOWING EMBERS
A bag of ceramic fiber embers is provided for use on the front burner tray.
CAUTION: Use only the type of ember material supplied with this appliance. Due to the irregular size of the ember material there may be more than required. The use of other foreign materials on the burners may create dangerous conditions.
If over time, through cleaning and servicing these embers require replacement, contact your nearest ENVIROGAS dealer for replacement embers.
Figure 16
1.Gently remove the ember material from the plastic bag. Spreading these pieces evenly across the front of the ember tray, Use only a single layer. Do not pile embers. Place a single row of embers on top of the front burner. (Figure. 16)
2.Carefully avoid any clumping or large build ups.
Do not pack down, leave embers loose.
3.DO NOT PLACE EMBERS ON THE REAR BURNER.
4.Upon the first light up, watch for ignition to all burner ports. If a long delay is noted:
a)First, wait for the appliance to cool down
b)Open the front door of the appliance.
c)Carefully reposition the embers making
sure that burner ports are not plugged solid or blocked
CAUTION: NEVER OPERATE THIS APPLIANCE WITH THE DOOR REMOVED
INSTALLING THE LOG
Carefully remove log from unit. Check to ensure there is no damage. It is very important to install this log in its proper position to insure safe optimum operating conditions.
1.Open the front door.
2.Place log with Burnt Area forward on log supports. By matching bottom pegs to the receiving holes in log supports.
3.Close door securely.
Figure 17
13