Enviro 828 BV. INS, 828 BV. FS owner manual Assembling Your Envirogas 828 Freestanding Appliance

13.Re-attach the hinged side flaps by sandwiching the surround panels between the mounting brackets and the hinged side flaps. secure with screws.

14.Re-install the stove top by inserting the locating screws, previously put into the surround panel top, through the holes in the back of the stove top. Push threaded studs through holes in top baffle and tighten nuts. Re-attach the top grill bar.

15.Be sure to maintain adequate clearances around air openings, do not block.

16.Place the log and ember set into the fire box. See instructions in section 11, INSTALLING LOG AND EMBER SET.

OPTIONAL ADJUSTABLE SKIRT FOR RAISED FIREBOX APPLICATIONS

ASSEMBLING YOUR ENVIROGAS 828 FREESTANDING APPLIANCE

1.Open the two hinged side panels, open the door.

2.Remove log and ember set and all wrapping material from the stove. Check for damage. If damage is observed, do not use unit and contact your local dealer.

3.Remove the two wood screws that secure the stove to the pallet, these are located through the square openings inside the side panels.

4.Place the stove on its back on the pallet. Pre-thread the 4 holes in the base of the stove that secure the pedestal to the stove using the 4 screws ( 5/16 hex washer heads) provided. Place pedestal so that the holes in the base of the stove align with those in the pedestal and tighten screws by hand first. Then tighten with a 5/16 socket wrench.

5.Return the unit to the upright position reinstalls the log set and embers as per instructions in section 11.

7