Enviro 828 BV. FS, 828 BV. INS owner manual Safety Precautions, General

Page 2

SAFETY PRECAUTIONS

FOR SAFE INSTALLATION AND OPERATION OF YOUR "ENVIROGAS" ROOM HEATER, PLEASE, CAREFULLY READ THE FOLLOWING INFORMATION:

All "ENVIROGAS" gas-fired appliances must be installed in accordance with these instructions. Carefully read all the instructions in this manual first. Consult the building authority having jurisdiction to determine the need for a permit prior to commencing the installation.

NOTE Failure to follow these instructions could cause a malfunction of the fireplace that could result in death, serious bodily injury, and/or property damage.

Failure to follow these instructions may also void your fire insurance and/or warranty.

CAN/CGA -B149 installation code in Canada or the National Fuel Gas Code ANSI Z223.1.2 in the USA.

To prevent injury, do not allow anyone who is unfamiliar with the operation to use the stove.

Always keep the area around these appliances clear of combustible material, gasoline or other flammable vapors and liquids.

These appliances should not be used as a drying rack for clothing or for hanging Christmas stockings or decorations.

GENERAL

Installation and repair should be done by a qualified service person. The appliance should be inspected before use and at least annually by a qualified service person. More frequent cleaning may be required due to excessive lint from carpeting, bedding material, etc. It is imperative that control compartments, burners and circulating air passageways of the appliance be kept clean.

Due to high temperatures the appliance should be located out of high traffic areas and away from furniture and draperies.

Children and adults should be alerted to hazards of high surface temperatures and should stay away to avoid burns or clothing ignition.

Young children should be carefully supervised when they are in the same room as the appliance.

Clothing or other flammable material should not be placed on or near the appliance.

FOR YOUR SAFETY

A qualified installer, service agency or the gas supplier must perform installation and service.

This installation must conform with local codes or, in the absence of local codes with the current

Due to the paint curing on the stove a faint odor and slight smoking will likely be noticed when the stove is first used. Open a window until the slight smoking stops. Always connect this gas stove to a chimney and vent to the outside of the building envelope. Never vent to another room or inside a building. Make sure you use the vent pipe that is specified. Make sure that the vent is properly sized and is of adequate height to provide the proper draft. Inspect the venting system annually for blockage and any signs of deterioration.

Do not operate with cracked or broken glass. Under no circumstances should this appliance be modified. Parts that have to be removed for servicing must be replaced prior to operating this appliance. Only parts supplied by ENVIROGAS should be used in this appliance and replacements should only be performed by a licensed or qualified service person.

Never use solid fuels such as wood, paper, cardboard, coal, or any other flammable liquids etc., in this appliance.

Do not use this heater if any part has been under water. Immediately call a qualified service technician to inspect the heater and to replace any part of the control system and any gas control which has been under water.

Do not abuse glass by striking or slamming door shut

2

Image 2
Contents For Your Safety What to do if YOU Smell GASSafety Precautions GeneralCode Approvals Table of ContentsSpecifications Fireplace Insert Clearances to Combustibles For Installations Above 2000 FeetDimensions and Clearances to Combustibles Freestanding Clearances to CombustiblesDeciding Where to Locate Your Freestanding Stove Primary InstallationAssembly and Installation Instructions Preparation for InstallationAssembling Your Envirogas 828 Freestanding Appliance Electrical Requirements Optional FANOrifice SIZES, Pressures and Btus GAS Line Connection and TestingNever USE Open Flame for Leak Testing Automatic Flue GAS Spill Switch VentingVenting Freestanding Models AIR Shutter Adjustment Installing the Glowing Embers Installing the LOGFor Your Safety Read Before Operating Operating InstructionsRoutine Maintenance Trouble Shooting Problem Possible Cause SolutionParts and Accessories Service Parts available from your local Envirogas DealerWarranty To the DealerInstallation Data Sheet EG-828 Insert BV. FPI