Vermont Casting 36CDVTRN, 36CDVRRN Operating Instructions, Glass Information, Louvre Removal

CDV Series Direct Vent Gas Fireplace

Operating Instructions

Glass Information

Only glass approved by CFM Corporation should be used on this fireplace.

•The use of any non-approved replacement glass will void all product warranties.

•Care must be taken to avoid breakage of the glass.

•Do not operate appliance with glass front removed, cracked or broken.

•Replacement glass (complete with gasket) is available through your CFM Corporation dealer and should only be installed by a licensed qualified service person.

Louvre Removal

Lower Clamps

	Window
	Frame
Window	Assembly
Frame	Pull Clamp
Assembly
	Hook
Push
Clamp

The top louvre panel is removed by lifting the panel vertically and pulling it away from the appliance. (Fig. 56) The lower access door is removed in the same manner.

2.

Louvre

1.

Glass Panel

FP1602

Fig. 56 Remove top louvre assembly.

Handle FP1228

Fig. 57 Window frame assembly removal.

Glass Cleaning

It is necessary to periodically clean glass. During start- up condensation, which is normal, forms on the inside of the glass. This condensation causes lint, dust and other airborne particles to cling to glass surface.

Also initial paint curing may deposit a slight film on the glass. It is therefore recommended the glass be cleaned two or three times with a non-ammonia based household cleaner and warm water (We recommend gas fireplace glass cleaner) within the first few weeks of operation.

Window Frame Assembly Removal

1.Turn the fireplace OFF (including the pilot)

2.If the unit has been operating allow time for the components to cool.

3.Remove the top louvre assembly.

4.Remove the lower louvre panel.

5.Release the two clamps securing the lower edge of the window frame assembly by pulling down on the handles. (Fig. 57)

6.Tilt the window frame assembly out slightly at the bottom, lift the window frame assembly up and away from the fireplace.

7.To replace the window frame assembly reverse the procedure.

After the initial cleaning process the glass should be cleaned two or three times during each operating season depending on the environment in the house.

Clean glass after first two weeks of operation.

Do not clean glass when hot.

Do not use abrasive cleaners.

Do not strike or slam the glass.

28 20010175