Meco 6623S8E641 manual Step Manifold Assembly, Step Shroud to Cart Assembly

Regulator hose this end

13

Step 10

Manifold Assembly

NOTE: Regulator hose is shipped attached to the Manifold. Regulator hose is not shown in some illustrations for clarity.

Insert valve stems out through front of control panel section of Shroud Assembly so that the holes in the valve brackets align with the holes in the control panel. Fasten in place with 8) M4 x .31” Bolts through the control panel into the valve brackets. The Regulator hose will be on the LEFT side.

M4 x .31” Bolt

8 pc

Step 11

Shroud to Cart Assembly

Lay the assembled Shroud on the floor with a spacer underneath to keep weight off of the valve stems. Place the cart frame inside the shroud with the legs to the outside of the shroud brackets and fitting in the notches in the bot- tom shroud frame. Attach the shroud to the cart with 4) 1/4-20 x .39” Bolts through the shroud brackets and into the threaded inserts on the inside of the front cart legs.

1/4-20 x .39” Bolt

4 pc

Note:

Shown without Regulator

Hose for clarity.