Meco 6623S8E641 manual Step Bowl and Cylinder Heat Shield Assembly, Brace Wire Attachment

16

Step 16

Bowl and Cylinder Heat Shield Assembly

Attach the Bowl and Cylinder Heat Shield to the cart with 4) 1/4-20 x .59” Bolts, 4) Fiber Washers and 4) 1/4-20 Nuts. See detail views below for specific steps.

A. Illustrates location of Bowl, Cylinder Heat Shield and hardware. (Note location of 1.5” long bolt)

B. Before bolts are inserted, verify that valve nozzles are inserted into the ends of the burner tubes as shown in Detail. C. Illustrates location of bolts extending through Bowl Supports for attachment of Nuts.

Step 16D.

Brace Wire Attachment

D. The short Brace Wire is attached by placing the loop at one end over the front left bowl mounting bolt before threading on the Nut. The lower end is attached to the left rear leg by removing the nut holding the lower leg to the U-Leg, placing the loop of the Brace Wire on the exposed end of the bolt then replacing the nut.

Valve

Valve

Nozzle

Burner Tube

1/4-20 x .59” Bolt

3 pc

Fiber Washer

4 pc

Fiber Washer under each bolt head

A

Cylinder

Heat Shield

B

C

Brace Wire

1/4-20 Nut

4 pc

D