Lighting the Side Burner

!WARNING

To reduce the risk of serious bodily injury or death from fire or explosion:

•Open Side Burner Lid before lighting the grill to prevent an explosion from gas build-up.

1.Open the Side Burner Lid. (Fig. 8) NOTE: Side Burner Lid is to remain open while the Side Burner is on or hot.

2.IMPORTANT: Make sure the Side Burner Control Knob is turned “Off” first. (Fig. 4 - P.27)

3.Turn the LP Gas Cylinder valve open counterclockwise until it stops. (Fig. 5 - P.27)

4.Push Side Burner Control Knob in and turn counterclockwise to the High position. (Fig. 4 - P.27)

5.Push the Igniter Button on the Main Control Panel in until the Burner is lit. Listen for the spark ignition and look to make sure the Burner is lit. If no spark, see Troubleshooting Section on page 37.

6.If the Burner fails to light, repeat Step 4-5.

If the Burner fails to light after three or four attempts following Steps 4-5, turn the Side Burner Control Knob to the “Off” position, and close the LP Gas Cylinder valve to dissipate any accumulated gas. Wait five minutes; then repeat the lighting procedures.

NOTE: If the Burners still fail to light, refer to Troubleshooting Section. The Burner can be lit manually, see

Manually Lighting the Side Burner.

Fig. 8

Open Lid

Manually Lighting the Side Burner

1.Open the Side Burner Lid.

2.IMPORTANT: Make sure Side Burner Control Knob is turned “Off” first.

3.Turn the LP Gas Cylinder valve open counterclockwise until it stops. (Fig. 5 - P.27)

4.Push Side Burner Control Knob in and turn counterclockwise to the High position.

5.Hold lit match near Burner.

6.If the Burner fails to light, repeat Steps 4-5.

Side Burner Control Knob

If the burner fails to light after three or four attempts following Steps 3-5, turn the Side Burner Control Knob to the “Off” position and close the LP Gas Cylinder valve to dissipate an accumulated gas. Wait five minutes; then repeat the lighting procedure.

NOTE: If the Burners still fail to light, refer to Troubleshooting Section.