TROUBLESHOOTING
PROBLEM | CHECK | SOLUTION | |
|
|
| |
Burners burn with a yellow or orange flame, in | Inspect spider/insect screens for possible obstructions.. | Clean spider/insect screens (refer to “ANNUAL | |
conjunction with the smell of gas. (This is normal for | (Blockage of holes..) | MAINTENANCE”).. | |
the burner lighting tube.) |
|
| |
Is fuel hose bent or kinked? | Straighten fuel hose.. | ||
Symptoms: | |||
|
| ||
Does burner light with a match? | Clean burners (refer to “MAINTENANCE”).. | ||
Burner does not light, or flame is low in HI position. | |||
|
| ||
Did you use the snap igniter several times until the main | Make sure to hold the control knob in for two seconds | ||
| |||
| burner lit (refer to “MAIN BURNER IGNITION”)? | after snapping the igniter and seeing the orange flame | |
|
| from the burner lighting tube.. | |
|
|
| |
| Does the igniter work? Do you see a spark when you | Try manually lighting the burner (refer to “MAIN BURNER | |
| repeatedly use the snap igniter? | MANUAL IGNITION”).. Call Customer Service.. | |
|
|
| |
Experiencing | Are you preheating barbecue in the prescribed manner? | All burners on HI for 10 to 15 minutes for preheating.. | |
m CAUTION: Do not line the slide out |
|
| |
Are the cooking grates and Flavorizer® bars heavily | Clean thoroughly (refer to “CLEANING”).. | ||
grease tray with aluminum foil. | coated with |
| |
|
| ||
| Is the bottom tray “dirty” and not allowing grease to flow | Clean bottom tray.. | |
| into catch pan? |
| |
|
|
| |
Burner flame pattern is erratic. Flame is low when | Are burners clean? | Clean burners (refer to “MAINTENANCE”).. | |
burner is on HI. Flames do not run the whole length |
|
| |
of the burner tube. |
|
| |
|
|
| |
Inside of lid appears to be “peeling.” (Resembles | The lid is porcelain enamel or stainless steel, not paint.. | Clean thoroughly (refer to “CLEANING”).. | |
paint peeling.) | It cannot “peel..” What you are seeing is |
| |
| that has turned to carbon and is flaking off.. |
| |
| THIS IS NOT A DEFECT. |
| |
|
|
| |
Cabinet doors are not aligned. | Check the adjustment pin on the bottom of each door.. | Loosen adjustment nut/s.. Slide door/s until aligned.. | |
|
| Tighten nut/s.. | |
|
|
|
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com®.
SIDE BURNER TROUBLESHOOTING
PROBLEM | CHECK | SOLUTION |
|
|
|
Side burner does not light. | Is gas supply off? | Turn supply on.. |
|
|
|
Flame is low in HI position. | Is the fuel hose bent or kinked? | Straighten hose.. |
|
|
|
Push button ignition does not work. | Does burner light with a match? | If match lights burner, check igniter.. Refer to “SIDE |
|
| BURNER MAINTENANCE”.. |
|
|
|
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com®.
30