Desa (V) CD36R(N, (V) CD36T(N, P) Operating Fireplace, Installing Logs and Glowing Embers

Page 25

HEARTH ACCESS AND ASSEMBLY (Cont.)

25

Installing Logs and Glowing Embers

OPERATING FIREPLACE - Manual Ignition System

For Your Safety Read Before Lighting

HEARTH ACCESS AND ASSEMBLY

Continued

INSTALLING LOGS AND GLOWING EMBERS

A 4 piece ceramic log set comes packed inside the unit firebox. Removal of glass door is necessary to unpack and assemble the logs and add hearth treatments. Follow steps under Removing/Replacing Glass Door, page 24 to access the logs and burner.

Assemble the logs and add burner treatments as follows:

1.Position the base log onto burner log mounts. (see Figure 56).

Note: The cut out on the bottom should fit over the mounts and the base log should be positioned against the rear panel

2.Position the holes on the bottom of the rear log over the pins on the base log Figure 53).

3.Position the top left log and top right log onto the rear log and base log as shown in (see Figure 54).

WARNING: The glass door must be securely in place before running this fireplace. Do not run this fireplace if glass is missing or broken.

4.Open the bag of ember materials.

5.Break apart about quarter sized pieces and place about a single layer along the full length of the ember tray to hide the bottom edge of the base log. (see Figure 57).

6.Replace the glass door and louver panels. See Removing/ Replacing Glass Door, page 24.

TOP

LEFT

LOG

REAR

LOG

REAR LOG

STAND

TOP

RIGHT

LOG

REAR

PANEL

EMBER

TRAY

EMBER

MATERIAL

Figure 57 - Applying Ember Material

OPERATING FIREPLACE

Manual Ignition System

FOR YOUR SAFETY READ

BEFORE LIGHTING

WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing prop- erty, damage, personal injury or loss of life.

LOG MOUNTS

BURNER

PAN

Figure 56 - Installing Logs

A.This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly.

B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floorbecause some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

Do not try to light any appliance.

Do not touch any electric switch; do not use any phone in your building.

Immediately call your gas supplier from a neighbor’s Phone. Follow the gas supplier’s instructions.

116035-01B

www.desatech.com

Image 25
Contents For Your Safety OWNER’S Operation Installation ManualFor Your Safety What to do if YOU Smell GAS Dedicated Rear and TOP Vent FireplacesSafety Information Local Codes Safety Information Product IdentificationPRE-INSTALLATION Preparation Product FeaturesClearances PRE-INSTALATION PreparationFraming and Finishing Mantel Clearances Unit DimensionsMinimum Clearances for Termination Cap Location of Termination CAPInstallation Precautions Venting Installation InstructionsInstallation Planning Installing Siding Standoff With Vinyl Siding Horizontal Termination ConfigurationGround Floor Installation TOP Vent Venting with Three 90 Elbows Venting with Two 90 ElbowsFlat Ceiling Installation Vertical Termination Configurations Vertical Venting Parts Lists for Venting Kits and ComponentsNumber Description Model BK Installation Optional Blower InstallationElectrical Supply Connection Model BKT Installation Wiring Diagram Decal Front of BlowerMillivolt Wiring Scheme Wiring DiagramsInstalling Optional Wall Mount Switch GWMS2 Installing Optional ControlsInstalling Remote Receiver Receiver Volt Alkaline Battery Terminal Wires Battery ClipInstalling GAS Piping to Fireplace High Altitude InstallationGAS Supply and Piping Check GAS TypeInstallation Items Needed Connecting Fireplace to GAS SupplyNatural From Propane/LPTest Pressures In Excess of 1/2 Psig 3.5 kPa Checking GAS ConnectionsTest Pressures Equal To or Less Than 1/2 Psig 3.5 kPa EquipmentOpen Shutoff Valve ClosedHearth Access and Assembly For Your Safety Read Before Lighting Installing Logs and Glowing EmbersOperating Fireplace Lighting Instructions Manual Lighting ProcedureTo Turn OFF GAS To Appliance Optional HAND-HELD Remote OperationOperating Fireplace Electronic Ignition System Optional Wireless Remote OperationThermostat Series Model Ghrctb ON/OFF Series Model GhrcbInspecting Burners Glass Door Cleaning and MaintenancePilot and Burners LogsObserved Problem Possible Cause Remedy TroubleshootingInlet gas pressure is too low Gas leak. See Warning statement Ment Parts, Gas leak. See Warning statement at Service Hints Replacement PartsTechnical Service SpecificationsIllustrated Parts Breakdown KEY VCD36RN VCD36TN VCD36RP VCD36TP Description QTY Parts ListIllustrated Parts Breakdown KEY VCD36RN VCD36RP VCD36TN VCD36TP Description QTY 29 2 KEY VCD36RNE VCD36RPE VCD36TNE VCD36TPE Description QTY Accessories 116035-01B OWNER’S Registration Form Industrial Drive Box Bowling Green, KY Page Industrial Drive P.O. Box Model Serial No Date Purchased