Desa (V) CD36T(N, (V) CD36R(N, P) installation manual Optional Wireless Remote Operation

OPERATING FIREPLACE - Electronic Ignition System	27
For Your Safety Read Before Lighting

Lighting Instructions

To Turn Off Gas To Appliance

Optional Wireless Remote Operation

OPERATING FIREPLACE

Electronic Ignition System

FOR YOUR SAFETY READ

BEFORE LIGHTING

WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing prop- erty, damage, personal injury or loss of life.

A.This appliance is equipped with an ignition device which automatically lights the pilot. Do not try to light the pilot by hand.

B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floorbecause some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

•Do not try to light any appliance.

•Do not touch any electric switch; do not use any phone in your building.

•Immediately call your gas supplier from a neighbor’s Phone. Follow the gas supplier’s instructions.

•If you cannot reach your gas supplier, call the fire department.

C.Do not use this appliance if any part has been under water. Immediately call a qualified service techni- cian to inspect the appliance and to replace any part of the control system and any gas control which has been under water.

LIGHTING

INSTRUCTIONS

NOTICE: During initial operation of a new heater, the burning of residues from the manufacturing process of the firebox and logs will produce a paper-burning smell and orange flames. Open a window for the first few hours of operation to adequately vent this smell.

Equipment Shutoff Valve	Adjustment
	Screw
OFF

ON

Figure 59 - Turning Equipment Shutoff Valve to the OFF Position

TO TURN OFF GAS

TO APPLIANCE

1.Turn off the wall switch.

2.Turn off all electric power to the appliance if service is to be performed.

3.Open lower louver panel.

4.Turn equipment shutoff valve clockwise to OFF. Do not force.

5.Close lower louver panel.

1.	STOP! Read the safety information above.
2.	Turn off all electrical power to the fireplace.
3.	Turn wall switch to the OFF position.
4.	Open lower louver panel.
5.	Turn equipment shutoff valve clockwise	to the OFF
	position (see Figure ##). Do not force.
6.	Wait five (5) minutes to clear out any gas. Then smell for.
	gas, including near the floor. If you smell gas, STOP! Fol-
	low “B” in the safety information above. If you don’t smell

Pilot Burner

Figure 60 - Pilot

Sensor Rod

Ignitor

	gas go to the next step.
7.	Turn equipment shutoff valve counterclockwise		to.
	the ON position. Do not force.
8.	Close lower louver panel.
9.	Turn on all electric power to the fireplace.
10.	Turn the wall switch to the ON position.
11.	Visually locate the pilot. The ignitor should begin to spark and
	the main burner should ignite once flame appears at pilot.
	•	If lighting the appliance for the first time each season, it
		may take several attemps before the supply gas can reach
		the pilot and main burner.
	•	If the appliance will not stay lit after several attempts,
		follow the instructions To Turn Off Gas To Appliance, be-
		low, and call your service technician or gas supplier.

OPTIONAL WIRELESS

REMOTE OPERATION

Note: The WRC receiver and hand-held remote control kit must be purchased separately (see Accessories, page 43). Follow installation instructions included with the remote control.

1.Turn equipment shutoff valve to ON position. You can now turn the burner on and off with the hand-held remote unit.

IMPORTANT: Be sure to press the ON/OFF buttons on the hand-held remote control unit for up to 3 seconds to assure proper operation.

2.Press the ON/OFF button to turn the burner on and off.

116035-01B www.desatech.com