Desa T32p-a SERIES Fireplace Installation, Check GAS Type, Installing optional blower accessory

Venting Installation

instructions

	Continued
Number	Description
VKR-58	Roof Vent Kit, Galvanized
	(Includes: 45° Elbow, 7"-12"
	Adjustable Pipe, Flue Restrictor,
	Vertical High Wind Termination,
	2' Pipe, 4' Pipe, Wall Firestop,
	Storm Collar, Roof Flashing
	[0/12 - 6/12], 26 Screws)
VKC-58	Corner Vent Kit, Galvanized
	(Includes 45° Elbow, 7"-12"
	Adjustable Pipe, Wall Firestop,
	Horizontal Termination, 6" Pipe,
	90° Elbow, 18 Screws)
HHTK-58	High Wind Round Horizontal
	Termination Kit (Includes Round
	Termination, Wall Firestop,
	45° Elbow)
HHT-58	High Wind Round Termination Kit,
	Galvanized
HTK-58	Horizontal Round Termination Kit
	(Includes Round Termination,
	Wall Firestop, 45° Elbow)
HT-58	Horizontal Round Termination,
	Galvanized
HTS-58	Horizontal Square Termination,
	Galvanized
HTKS-58	Horizontal Square Termination Kit
	(Includes: Square Termination,
	Wall Firestop, 45° Elbow)
HTS-58	Horizontal Square Termination,
	Galvanized
VT-58	Vertical Round Termination,
	Galvanized
ST-58-14	14" Snorkel Termination,
	Galvanized
ST-58-36	36" Snorkel Termination,
	Galvanized
SC-58	Storm Collar, Galvanized
WF-58	Wall Firestop, Galvanized
RF-58-6	Roof Flashing - 0 to 6/12 Pitch,
	Galvanized
RF-58-12	Roof Flashing - 6/12 to 12/12
	Pitch, Galvanized
VR-58	Vertical Restrictor, Galvanized
S-58	Vinyl Siding Standoff,
	Galvanized
WS-58	Wall Strap
CS-58	Cathedral Ceiling Support
FP-58	Firestop Plate
SF-58	Stucco Flashing - For use
	with HTS-58
RF-58	Flat Roof Flashing

Fireplace

Installation

CHECK GAS TYPE

Use proper gas type for the fireplace unit you are installing. If your gas supply is not correct, do not install fireplace. See retailer where you purchased the fireplace for proper fireplace according to your gas type or to purchase gas conversion kit (see Ac- cessories, page 37).

Installing optional blower accessory

NOTICE: If installing blower in an existing fireplace with gas connections, shut off gas sup- ply and disconnect heater from gas supply. Contact a qualified service person to do this.

WARNING: If there is a duplex electrical outlet installed in the right side of the bottom of the fireplace base area, be sure that theelectricalpowertotheoutletis turned off before proceeding with blower installation. Failure to do this may result in serious injury.

Model BK Installation

Follow all instructions provided in the blower accessory kit.

1.Attach the power cord to the blower motor by firmly pushing the two female terminals at the end of the power cord onto the two spade terminals on the blower motor (see Figure 26).

2.Attach green ground wire from power cord to blower housing using screw provided (see Figure 26). Tighten screws securely.

Side View	Blower
Lower Firebox	Location
	Magnetic
Cavity
	Strips
Spade
Terminals

Green

Ground

Wire

Screw Exhaust

Port

Figure 26 - Blower Model BK

116646-01D www.desatech.com 17