Desa T32N-a SERIES, CGDV32pR, T32p-a SERIES installation manual Thermostat Series, On/Off Series

OPERATIng fireplace

Continued

IMPORTANT: Do not leave the selector switch in the REMOTE or ON position when the pilot is not lit. This will drain the battery.

Thermostat Series

(Model HRC200 and HRC201)

The hand-held remote can be operated using either the manual mode (MANU) or thermostatic mode (AUTO) (see Figure 54). To select Fahren- heit/Centigrade mode display, carefully press the

Blower Control Knob (Optional Accessory)

OFF ON

REMOTE

OFF

ON

Variable Control Knob

N
O	L
T	O	I
O	O	H
L
IP FF

˚C/˚F mode button with the end of a paper clip or similar blunt object.

Manual Mode

1. Press the POWER and LOCK buttons togeth- er to turn on the hand-held remote control.

2. Press the MANU button to turn on the fireplace.

Gas Control Knob

Selector Switch in in ON Position

Remote Position

Figure 52 - Setting the Selector Switch,

Gas Control Knob and Variable Control

Knob for Remote Operation

On/Off Series

(Model HRC100 and HRC101)

Hold the control button on the hand-held remote until burner turns on. Hold the control button again until burner turns off (see Figure 53).

To Lock press both buttons on hand-held remote control until light stops flashing. Hand- held remote control is now locked. If the fire is on it will be turned off automatically. In the locked state, the light will not light up when any button is pressed.

To Unlock press both buttons together on hand-held remote control until the light stops flashing. The hand-held remote is now unlocked.

Indicator

Light

Control

Button

Figure 53 - On/Off Hand-Held Remote

Control Unit (HRC100/HRC101)

3. Press the POWER and LOCK buttons together to turn off the fireplace.

Auto (Thermostatic) Mode

1. Press the POWER and LOCK buttons togeth- er to turn on the hand-held remote control.

2. Press AUTO button to select this mode.

3. Set the desired room temperature by pressing the TEMP + or - buttons.

4. Press the POWER and LOCK buttons together to turn off the fireplace.

Note: Do not leave the hand-held remote in the AUTO mode close to the fireplace. The radiant heat from the fireplace will turn off the fireplace. Ideally, place the hand-held remote in the center of the room facing towards the fireplace.

Note: Do not hold the hand-held remote for a long time. Body temperature will affect its operation in the AUTO mode.

Digital Display Shows

Temperature and Settings

Locks
System to				Turns
Prevent		AUTO
				Hand-Held
Accidental	ROOM		SET
	TEMP		TEMP	Remote On
Ignition
				or Off and
		TEMP
	LOCK		POWER	Allows You
Turns
				to Choose
Burners
				the Manual
On or Off	MANU	ºC/ºF	AUTO
				Setting
Increases or				Selects
Decreases
				AUTO
Room
				Mode
Temperature
in AUTO
Mode	°C/°F Mode Button

Figure 54 - Thermostat Hand-Held

Remote Control Unit (HRC200/HRC201)

28 www.desatech.com 116646-01D