Desa T32p-a SERIES, CGDV32pR, T32N-a SERIES Table of Contents, Safety Information

Page 2

Table of Contents

Safety Information

2

Cleaning and Maintenance.

...............................

30

Product Identification

4

Troubleshooting

32

Local Codes

4

Replacement Parts

36

Product Features

4

Service Hints

36

Pre-Installation Preparation

5

Technical Service

36

Location of Termination Cap

7

Specifications

36

Venting Installation Instructions

8

Accessories

37

Fireplace Installation

17

Illustrated Parts Breakdown and Parts List

38

Operating Fireplace

26

Warranty Information

Back Cover

Inspecting Burners

29

 

 

 

Safety Information

WARNING: Improper in- stallation, adjustment, al- teration, service or main- tenance can cause in- jury or property damage. Refer to this manual for correct installation and operational procedures. For assistance or addi- tional information con- sult a qualified installer, service agency or the gas supplier.

This appliance may be in- stalled in an aftermarket,* permanently located, manufactured (mobile) home, where not prohib- ited by local codes.

This appliance is only for use with the type of gas indicated on the rating plate. This appliance is not convertible for use with other gases, unless a certified kit is used.

*Aftermarket: Completion of sale, not for purpose of resale, from the manufacturer

State of Massachusetts: The installation must be made by a licensed plumber or gas fitter in the Commonwealth of Massachusetts.

WARNING: This product contains and/or generates chemicals known to the State of California to cause cancer or birth defects or other reproduc- tive harm.

IMPORTANT: Read this owner’s manual carefully and completely before trying to assemble, op- erate or service this fireplace. Improper use of this fireplace cancause serious injury or death from burns, fire, explosions, electrical shock and carbon monoxide poisoning.

DANGER: Carbon monoxide poisoning may lead to death!

This fireplace must be installed by a qualified (cer- tified or licensed) service person. It has a sealed gas combustion chamber that uses a coaxial pipe (pipe within a pipe and having the same center) venting system. It brings in fresh air for combus- tion through the outer pipe and combustion gases are exhausted through the inner pipe. If the glass door assembly and venting pipe are not properly seated, connected and sealed, carbon monoxide leakage (spillage) can occur.



www.desatech.com

116646-01D

Image 2
Contents PROPANE/LP GAS Tudor Models VT32P-A Series Natural GAS Tudor Models VT32N-A SeriesCGDV32NR CGDV32PRTable of Contents Safety InformationHigh traffic areas Local Codes Product FeaturesProduct Identification Clearances Pre-Installation PreparationLocation and space requirements Proper clearances must be maintainedFraming Clearances for Corner Installation Location of Termination Cap Termination CAP AIR Supply Inlet GAS MeterVenting Installation Instructions Installation PrecautionsInstallation Planning Female Locking Lugs Male SlotsInstalling Siding Standoff Combustible Exterior Vertical V Horizontal H Venting InstallationSquare Termination Round Termination Kit HTK ShownCorner Installation Horizontal System Installation Using TWO 90 Elbows Venting with Two 90 ElbowsConnect a section of pipe and extend up through the hole Installation for vertical terminationFlat Ceiling Installation Twist-lock the vent cap onto the last section of vent pipe Venting with One 90 Elbow Vertical V Horizontal HVertical Venting High Altitude InstallationParts list for venting kits and components Desa 5/8 Pipe & Vent Kits Number DescriptionModel BK Installation Fireplace InstallationInstalling optional blower accessory Check GAS TypePlug in blower power cord Model BKT InstallationPlug in blower power cord to duplex outlet Blower Wiring DiagramInstalling Gas Piping to Fireplace Location Installation Items NeededWrong, fireplace may not run properly Connecting Fireplace to GAS SupplyChecking GAS Connections Test Pressures Equal To or Less Than Psig 3.5 kPa Installing optional wall Mount Switch gwmS2Pressure Testing Fireplace Gas Connections Removing Louver Panels Installing Remote ReceiverRemoving/Replacing Glass Door Cleaning Glass Door Installing Optional Brick liner Model BL32DReplace screen/rod assembly by reversing step Removing Glass DoorInstalling logs, lava rock and glowing embers Close top and bottom louversFor Your Safety Read Before Lighting Operating FireplaceTo Turn OFF GAS To Appliance Manual Lighting ProcedureLighting Instructions Optional Hand-HeldThermostat Series On/Off SeriesInspecting Burners Operating optional blower accessoryPilot Assembly Operating optional GWMT1 Wall Mounted ThermostatGlass Door Cleaning MaintenanceBurner Flame Pattern Venting system Pilot and burnersLogs Troubleshooting Observed Problem Possible Cause RemedyDelayed ignition burner Problem could be caused by Replace pilot assemblyBurner orifice clogged Clean burner see Cleaning Is lit After pilot lights, keep gasCold Minute Air in gas line Operate burner until air is When burner is lit HI position when burner isImproper vent cap installa MixerGas leak. See Warning Statement aboveTechnical Service Replacement PartsService Hints SpecificationsAccessories Illustrated Parts Breakdown Parts List Illustrated parts breakdown Burner Base Assembly 116646-01D 116646-01D Limited Warranty DIRECT-VENT Fireplace Warranty InformationKeep this Warranty