14
INSTALLATION
Assembling And Attaching Trim (Cont.) Installing Logs
INSTALLATION
Continued
8.Line up holes in surround trim with holes on side panels of fireplace surround assembly. Attach with screws provided (see Figure 22).
9.Move heater and surround assembly to fireplace opening. Make sure heater and surround assembly fit properly.
Fireplace | #6 Screws (4) | |
Surround | ||
|
Trim
2.Install fireplace insert screen by slipping notches of fireplace in- sert screen over screws on front of fireplace insert (see Figure 25).
WARNING: You must operate this fireplace in- sert with the fireplace insert screen in place. Make sure fireplace insert screen is in place before run- ning fireplace insert.
One Piece
Log Set
Middle Section
at Bottom of
Log Set
Burner
Figure 22 - Attaching Trim to Fireplace Surround
INSTALLING LOGS
CAUTION: Do not remove the warning and in- struction labels attached to the heater base assem- bly. These markings contain important warranty and safety information.
WARNING: Failure to position the parts in accor- dance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.
WARNING: After installation and periodically there- after, check to ensure that no flame comes in contact with any log. With the heater set to HI, check to see if flames contact any log. If so, reposition logs accord- ing to the log installation instructions in this manual. Flames contacting logs will create soot.
It is very important to install the logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.
1.Place
IMPORTANT: Make sure log does not cover any burner ports.
Chassis | |
| Cutout in |
| Chassis |
Figure 23 - Installing One Piece Log Set |
| |
Burner | One Piece | |
Ports | ||
Log Set | ||
|
Figure 24 - Installing One Piece Log Set (Top View)
Screws for
Mounting
Screen
Notches
Figure 25 - Installing Fireplace Insert Screen
For
.
.com
