INSTALLATION
Installing Surround Kit (Cont.)
Installing Hood
Installation Clearances
9
INSTALLATION
Continued
6.Align screw holes in side panels with holes in top panel (see Figure 9). Insert and tighten #10 Phillips screws.
7.Reinstall louver removed in step 4.
8.Carefully inspect fireplace surround assembly. Make sure each part fits properly. Firmly tighten all screws installed during assembly.
CAUTION: Do not overtighten. Metal can bend, warp, or break under excessive strain.
9.Install trim after final finishing and/or painting of wall.
Top Edge of
Fireplace Insert
Top Surround
Panel
Phillips
Screws (4)
Figure 8 - Attaching Top Surround Panel
Top Panel
Phillips Screws
Side Panel
Figure 9 - Attaching Side Panels to Top Panel
INSTALLING HOOD
Install hood to top of firebox as shown in Figure 10. Use 5 Phillips screws, provided, to attach hood to fireplace insert and 2 Phillips screws, provided, to attach hood and surround sides to fireplace insert.
Screws
Figure 10 - Installing Hood to Firebox
INSTALLATION CLEARANCES
WARNING: Maintain the minimum clearances. If you can, provide greater clearances from floor, ceil- ing, and adjoining wall.
Carefully follow the instructions below. This will ensure safe installation.
Minimum Clearances For Side Combustible Material, Side Wall, and Ceiling
A.Clearances from the side of the fireplace cabinet to any com- bustible material and wall should follow diagram in Figure 12, page 10.
Example: The face of a mantel, bookshelf, etc. is made of combustible material and protrudes 3 1/2" from the wall. This combustible material must be 4" from the side of the fireplace opening (see Figure 11).
B.Clearances from the top of the fireplace opening to the ceiling should not be less than 42 inches.
Example |
* |
*Minimum 16 inches from Side Wall
Figure 11 - Minimum Clearance for Combustible to Wall
For more
visit www.
.com
