INSTALLATION
Optional Wireless
15
INSTALLATION
Continued
OPTIONAL WIRELESS
Installing Remote Receiver Unit
1.Disconnect switch wires from the control valve.
2.Remove screws attaching switch plate.
3.Remove switch plate (see Figure 26). Discard after removing.
4.Install remote receiver unit onto gas log heater base using mounting clips.
5.Push clips firmly into place (see Figure 27).
6.Connect wires as shown in Figure 28.
Remote Switch | Ignitor | |
Bracket | ||
| ||
Screw |
|
Wires
Switch
Plate
Figure 26 - Switch Plate and Wiring Harness
Mounting
Clips
Installing 9-Volt Battery (Not Included) in Receiver
1.Locate back of receiver under front burner of heater.
2.Locate the battery clip mounted on the back of the receiver.
3.Slide a
4.Attach the terminal wires to the battery.
Remote
Receiver
Battery 
Terminal Battery Clip Wires
Figure 29 - Installing Battery in Remote Receiver
Installing
1.Remove battery cover on back of remote control unit.
2.Attach terminal wires to the battery. Place battery into the bat- tery housing.
3.Replace battery cover onto remote control unit.
Remote Receiver 
Figure 27 - Installing Remote Receiver
Battery
Cover
Terminal Wires
Remote
Control Unit
Battery
Housing
White Wire |
| |
From | Valve | |
Receiver | ||
|
Red Wire
From
Receiver
Figure 28 - Connecting Wires
INSTALLING 9-VOLT BATTERIES
Two
Figure 30 - Installing Battery in Hand-Held Remote Control Unit (GHRCB Series)
Terminal | ||
Wires | ||
Battery | ||
|
Remote
Control
Unit
Battery 
Cover
Figure 31 - Installing Battery in Hand-Held Remote Control Unit (GHRCTB Series)
For more
visit www.
.com
