Desa VI33NR VI33PR Product Identification, Unpacking, Remote Control Accessories

4

PRODUCT IDENTIFICATION UNPACKING

REMOTE CONTROL ACCESSORIES PRODUCT FEATURES

PRODUCT IDENTIFICATION

One Piece

Log Set

Optional

Remote

Control

	IH
	O
	NO FF
Control Knobs
Piezo	Remote Selector
Ignitor	Switch (Optional)

Figure 1 - Log Base Assembly

Top Louver

Assembly

Firebox	Top Outer
Hood	Casing

Firebox

Support

Gas

Line

Access

Screen

AssemblyBlower

Assembly

Bottom Louver

Assembly

Figure 2 - Fireplace Insert

UNPACKING

CAUTION:Do not remove the warning and instruction labels attached to the heater base assembly. These mark- ings contain important warranty and safety information.

1.With utility knife, cut the carton all the way around above the staples on the bottom tray. Lift the carton off the heater. Remove packing. Note: The hood is located in the packing on the right hand side of the heater front. Lift the heater off the bottom tray.

2.Locate two screws above top corners of the fireplace insert screen. Remove and discard these screws. Lift fireplace insert screen up and pull out to remove.

3.Remove protective packaging applied to logs, log base assem- bly, and fireplace insert.

4.Remove fireplace insert hood from carton insert.

5.Check all items for any shipping damage. If damaged, promptly inform dealer where you bought fireplace insert.

REMOTE CONTROL

ACCESSORIES

There are four optional remote controls that can be purchased separately for this fireplace insert:

•wall switch

•wall thermostat

•hand-held ON/OFF remote

•hand-held thermostat remote

See Accessories, page 30.

PRODUCT FEATURES

OPERATION

This vent-free fireplace insert is clean burning. It requires no outside venting. There is no heat loss out a vent or up a chimney. Heat is generated by both realistic flames and glowing embers. When used without the blower, the fireplace insert requires no electricity making it ideal for emergency backup heat.

SAFETY DEVICE

This fireplace insert has a pilot with an Oxygen Depletion Sensing (ODS) safety shutoff system. The ODS/pilot is a required feature for vent-free room heaters. The ODS system shuts off the fireplace insert if there is not enough fresh air.

PIEZO IGNITION SYSTEM

This fireplace insert has a piezo ignitor. This system requires no matches, batteries, or other sources to light fireplace insert.

BLOWER ASSEMBLY

This fireplace insert is equipped with a blower assembly. The blower operatesthermostaticallyandhasavariablecontrol.Theblowercirculates heatedairfromthefireplaceinsertintotheroom.Useofblowerisoptional.

For..com

111285-01B