Desa VDCFTNB installation manual Product Identification, Local Codes, Product Features, Unpacking

Page 5

PRODUCT

IDENTIFICATION

Fireplace

Cabinet

Hood

Screen

Log
Ignitor Button	Control
	Control
	Knob
	Fireplace Cabinet
Hood
Logs
Ignitor
Button
Remote Control
(Optional)
	Control Knob
Figure 1 - Vent-Free Compact Dual Flame
Fireplace
OPTIONAL REMOTE
CONTROL ACCESSORIES
(For Remote-Ready Models Only)
There are four optional remote controls that
can be purchased separately for Remote-Ready
Models only:

•wall switch

•hand-held ON/OFF remote

•wall thermostat

•hand-held thermostat remote

See Accessories, page 40.

LOCAL CODES

Install and use ﬁreplace with care. Follow all local codes. In the absence of local codes, use the lat- est edition of The National Fuel Gas Code ANSI Z223.1/NFPA 54*.

*Available from:

American National Standards Institute, Inc. 1430 Broadway New York, NY 10018

National Fire Protection Association, Inc. Batterymarch Park Quincy, MA 02269

PRODUCT FEATURES

SAFETY PILOT

This ﬁreplace has a pilot with an Oxygen Deple- tion Sensing (ODS) safety shutoff system. The ODS/pilot is a required feature for vent-free room ﬁreplaces. The ODS/pilot shuts off the ﬁreplace if there is not enough fresh air.

PIEZO IGNITION SYSTEM

This ﬁreplace has a piezo ignitor. This system requires no matches, batteries or other sources to light ﬁreplace.

THERMOSTATIC HEAT CONTROL FOR THERMOSTAT-CONTROLLED MODELS

Thermostat-Controlled models have a thermostat sensing bulb and a control valve. The thermostat will automatically modulate the heat output to maintain a consistent room temperature. This results in greater ﬁreplace comfort. This can also result in lower gas bills.

UNPACKING

1.Remove fireplace and hood from carton. Log is wrapped and inside ﬁreplace. Do not remove at this time.

2.Remove all protective packaging applied to ﬁreplace for shipment.

3.Make sure your ﬁreplace includes one hard- ware packet.

4.Check ﬁreplace for any shipping damage. If ﬁreplace is damaged, promptly inform dealer where you bought ﬁreplace.

116526-01A

www.desatech.com

5

Image 5

Contents What to do if YOU Smell GAS Shown with Optional Cabinet Mantel/Hearth Base AccessoryTable of Contents Safety Information Safety Information Product Identification Product FeaturesLocal Codes UnpackingSheet Metal Screws Hood Louver Firebox Top Hood AssemblyTools Required Phillips screwdriver Shoulder Screw ScreenDetermining FRESH-AIR Flow for Fireplace Location AIR for Combustion VentilationProviding Adequate Ventilation Ventilation Air From Outdoors Ventilation AIRVentilation Air From Inside Building Check GAS Type InstallationFireplace Clearances Installation ItemsMinimum Clearance to Combustible Materials TopActual Framing Height BUILT-IN Fireplace InstallationFront Width DepthMantel Shelf Optional Mantel InstallationSide of Firebox Top Louver Bottom LouverInstalling Optional Blower Accessory GA3450TA Switch Power Cord Installing Blower AccessoryPlate Remote Wire Blower Harness Bracket Lower Louver Door SwitchBlower Bracket For Built-In InstallationExtension Cord Connecting to GAS Supply Checking GAS Connections Connecting Equipment Shutoff Valve to Heater ControlInstallation Items Needed Equipment Shutoff Valve Propane/LP Supply Tank Pressure Testing Fireplace Gas ConnectionsEquipment Open Shutoff Valve Closed Gas Regulator or Gas Control Valve EquipmentInstalling Receiver Optional Wireless HAND-HELD Remote Control AccessoriesReceiver Volt Terminal Battery Wires Battery Clip Installing 9-Volt Battery in Hand-Held Remote Control UnitFeed wires through rectangular slots Control Valve To Wall Thermostat or Switch Or SwitchInstall the base onto the wall with the pro- vided screws Remove jumper wire from control valve see ,For Your Safety Read Before Lighting Installing LOG SET and ScreenOperating Fireplace Lighting InstructionsTo Turn OFF GAS To Appliance Manual Lighting ProcedureThermostat Control Operation Shutting Off FireplaceOperating Blower REMOTE-READY Models For Your Safety Read Before LightingAUTO/OFF/ON Switch Pilot Burner Ignitor Electrode Piezo Flame Control Ignitor Adjustment Knob ButtonPilot Ignitor Burner Electrode Optional HAND-HELD Remote Operation Manual ModeThermostat Series Model HRC200 ON/OFF Series Model HRC100Optional GWMT1 Wall Mounted Thermostat Optional GWMS2 Wall Mounted SwitchInspecting Burners Cleaning MaintenanceCabinet LOG SETAir Passageways ExteriorObserved Problem Possible Cause Remedy TroubleshootingBurner oriﬁce is clogged Burner oriﬁce is clogged Clean burner see CleaningMote-Ready Models Only Models OnlyMote-Ready Models Only Power is low When heated, vapors fromSlight smoke or odor during Nance,Gas leak. See Warning Remote-Ready Models SpecificationsThermostat Models Firebox Models VDC Illustrated Parts BreakdownParts List Thermostat Models Vdcftpb and Vdcftnb Thermostat Models REMOTE-READY Models Vdcfrnb and Vdcfrpb KEY Part Numbers Vdcfrpb Vdcfrnb Description QTY Equipment Shutoff Valve GA5010 AccessoriesPerimeter Trim KIT GA6095 THERMOSTAT-CONTROLLED Blower KIT GA3450TFor all models. Creates the sound of a real burn- ing ﬁre Receiver and HAND-HELD Remote Control KIT HRC100 SeriesInformation Video Service Hints Replacement PartsTechnical Service Parts Under Warranty116526-01A Limited Warranty VENT-FREE Compact Classic Hearth Warranty InformationKeep this Warranty