INSTALLATION | INSTALLATION OPTIONS |
Continued | There are three options for mounting this heater. |
A. Mounting heater to wall |
B.Mounting heater to optional hearth base
C.Mounting heater with optional hearth base to optional mantel.
A. MOUNTING HEATER TO WALL
Mounting Bracket
The mounting bracket is located on back panel of heater. It has been taped there for shipping. Remove mounting bracket from back panel.
Mounting
Bracket
Figure 12 - Mounting Bracket Location
Methods For Attaching Mounting Bracket To Wall
Only use last hole on each end of mounting bracket to attach bracket to wall. These two holes are 16 inches apart from their centers. Attach mounting bracket to wall in one of two ways.
1.Attaching to wall stud
2.Attaching to wall anchor
Attaching to wall stud This method provides the strongest hold. Insert mounting screws through mounting bracket and into wall studs.
Attaching to wall anchor This method allows you to attach mounting bracket to hollow walls (wall areas between studs) or to solid walls (concrete or masonry).
Decide which method better suits your needs. Either method will provide a secure hold for the mounting bracket.
Marking Screw Locations
1.Tape mounting bracket to wall where heater will be located. Make sure mount- ing bracket is level.
WARNING
WARNING ICON | G 001 |
Maintain minimum clearances shown in Figure 13. If you can, provide greater clearances from floor and joining wall.
2.Mark screw locations on wall (see Figure 13).
Note: Only mark last hole on each end of mounting bracket. Insert mounting screws through these holes only.
3.Remove tape and mounting bracket from wall.
11" | 16" |
Min. |
|
| AdjoiningWall |
|
| Only Insert Mounting | 20 3/4" |
| Screws Through Last | Min. |
| Hole On Each End | |
|
| |
| Floor |
|
| Figure 13 - Mounting Bracket Clearances | |
14 | ||
101935