Desa RFP28TB installation manual Operating Heater, For Your Safety Read Before Lighting

Page 23

OPERATING HEATER

FOR YOUR SAFETY READ BEFORE LIGHTING

WARNING

WARNING ICON

G 001

If you do not follow these instructions exactly, a fire or explo- sion may result causing property damage, personal injury or loss of life.

A.This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly.

B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

Do not try to light any appliance.

Do not touch any electric switch; do not use any phone in your build- ing.

Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.

If you cannot reach your gas supplier, call the fire department.

C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don’t try to repair it, call a qualified service technician or gas supplier. Force or attempted repair may result in a fire or explosion.

D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.

LIGHTING INSTRUCTIONS

1.STOP! Read the safety information above.

2.Make sure manual shutoff valve is fully open.

3. Turn control knob clockwise Clockwise to the OFF position.

Ignitor Button

Control Knob

LO

PILOT

OFF HI

IGNITOR

Control Knob & Ignitor Button GRH/OV 015

Figure 28 - Control Knob In The OFF Position

Continued

101935

23

Image 23
Contents What to do if YOU Smell GAS OWNER’S Operation and Installation ManualSafety Information ContentsSafety Information Thermostatic Heat Control Safety DeviceProduct Identification Piezo Ignition SystemRemoving Front Panel Of Heater AssemblyInstalling Log Assembling Heater Attaching Brass Front Trim to Front PanelAssembling and Attaching Brass Trim AssemblyProviding Adequate Ventilation AIR forVentilation Determining if You Have a Confined or Unconfined Space AIR for Combustion and VentilationDetermining AIR Flow for Heater Location Appliances in both spaces Ventilation AIRVentilation Air From Inside Building Ventilation Air From Outdoors Ventilation AIRLocating Heater InstallationInstallation Items Check GAS TypeAttaching Thermostat Sensing Bulb Thermostat Sensing BulbLocating Thermostat Sensing Bulb Marking Screw Locations Installation OptionsMounting Bracket Methods For Attaching Mounting Bracket To WallPlacing Heater On Mounting Bracket Attaching Mounting Bracket to WallMounting Heater on Optional Hearth Base Securing Hearth Base to FloorAttaching Heater to Hearth Base Mounting Heater to Optional Hearth BaseAssembling Mantel Installing Mantel to HeaterPre-Drilled Hole Screw Hearth Base Accessory Wood Plug External Regulator with Vent Pointing Down Connecting to GAS SupplyChecking GAS ConnectingTo GAS SupplyChecking Pressure Testing Heater GAS ConnectionsOperating Heater For Your Safety Read Before LightingPilot Shutting Off Burner Only pilot stays lit Shutting Off HeaterPilot Flame Pattern Inspecting BurnerCorrect Burner Flame Pattern Burner Flame PatternCabinet Trouble ShootingODS/PILOT and Burner Trouble Cleaning and MainteTROUBLE- Shooting Ing statement at If you smell gasShut off gas supply Do not try to light any applianceHints ServiceReplacement Parts TechnicalFBD Parts CentralsGS601 Black Surround AccessoriesFAN KIT GA3100A Manual or GA3200TA Thermostat Hearth Base GHB802B or GHB38Unfinished GMC33U Finished GMC32F Unfinished GMU801A,B Finished GMF800A,BUnfinished GMC23UA Finished GMC22FA RFP28TB KEY Part Number Description Parts List RFP28TB101935 101935 Keep this Warranty Warranty Information