Weber 55204 manual Insert casters Add cooking box assembly

Page 13

Insert casters	Add cooking box (assembly)
You will need: frame assembly and two casters.	You will need: frame assembly, cooking box
Push the casters firmly into the inserts in the ends of	(assembly), 2 inch bolt, nylon washer, keps nut, pliers
the caster frame.	and a 7/16 inch or adjustable wrench.
	Place the cooking box (assembly) in the frame
	assembly so the burner tubes(1) are under the frame
	brace(2).

(1)

(2)

Slide the cooking box (assembly) to the left within the frame assembly. Add the nylon washer to the bolt. Insert the bolt through the cooking box and frame with the head of the bolt outside the box. Add the keps nut. Tighten by holding the bolt with pliers while you tighten the nut with a wrench.

B-3

Image 13

Contents Extinguish any open flames If you smell gas Shut off gas to the applianceLiquid Propane GAS Units only South Hicks Road Customer Service CenterPalatine, IL Contents For Installation in Canada Gas Supply TestingStorage OperatingGenesis Silver-B NG Page Page Page Page Assembly Instructions Continue frame assembly Complete frame assembly Insert casters Add cooking box assembly You will need manifold bracket Install manifold bracketIgniter lock nut with an adjustable wrench or pliers Install igniterGas Catcher Ignition Chamber and the igniter. This Was done to factory test the ignition systemLeaks. Be sure there are no sparks or open Do not use an open flame to check for gasFlames in the area while you check for gas Leaks. This will result in a fire or explosionPage Representative in your region using the contact BARBECUE. Contact the Customer ServiceCheck for gas leaks Or3 turn OFF the gas. do not OperateInstall Lid Install the slide out bottom trayGrease and not allowing grease to flow into Catch panRight swing-up work surface Install the right end trim piece with tool holdersView inside of control panel Shown, do not push the trim piece in all Install the left end trim piece and swing-up workWay and do not add bolts yet Do not use the swing-up work surface as a cutting BoardDo not use the work surface as a cutting board Install the work surfaceYou will need work surface Page Install the bottom shelf Install the thermometerYou will need Thermometer You will need Bottom shelfTo Extinguish LightingSummary lighting instructions are on the control panel Manual Lighting Cooking CleaningStorage Inspection and Cleaning of the Weber Spider Stopper Guards Annual MaintenanceMain Burner Cleaning Procedure General MaintenanceWeber Spider Stopper Guards Replacing Main Burners Crossover Ignition System Operations Burners burn with a yellow or Flame is low when burner is onOrange flame, in conjunction with Smell of gas