Weber 55204 manual Install igniter, Gas Catcher Ignition Chamber and the igniter. This

Page 15

Install igniter

The wire holder (1) is to keep ignition wires from

Note - The igniter wires are already attached to the

interfering with the swing-up table’s bracket. If the wire

Gas Catcher Ignition Chamber and the igniter. This

holder becomes loose, reinstall or replace it

was done to factory test the ignition system.

immediately.

The igniter lock nut is on the igniter.

 

1)

Loosen the igniter lock nut.

 

2)

Insert the top of the igniter up through the large

 

 

part of the keyhole in the frame brace. Slide the

 

 

igniter into the small part of the keyhole.

 

3)

Tighten the igniter lock nut back onto the igniter.

 

Note - If the igniter works loose, carefully tighten the

(1)

igniter lock nut with an adjustable wrench or pliers.

 

(1)

(2)

(3)

B-5

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Extinguish any open flames If you smell gas Shut off gas to the applianceLiquid Propane GAS Units only Customer Service Center South Hicks RoadPalatine, IL Contents Operating Gas Supply TestingFor Installation in Canada StorageGenesis Silver-B NG Page Page Page Page Assembly Instructions Continue frame assembly Complete frame assembly Insert casters Add cooking box assembly You will need manifold bracket Install manifold bracketWas done to factory test the ignition system Install igniterIgniter lock nut with an adjustable wrench or pliers Gas Catcher Ignition Chamber and the igniter. ThisLeaks. This will result in a fire or explosion Do not use an open flame to check for gasLeaks. Be sure there are no sparks or open Flames in the area while you check for gasPage Or3 turn OFF the gas. do not Operate BARBECUE. Contact the Customer ServiceRepresentative in your region using the contact Check for gas leaksCatch pan Install the slide out bottom trayInstall Lid Grease and not allowing grease to flow intoRight swing-up work surface Install the right end trim piece with tool holdersView inside of control panel Do not use the swing-up work surface as a cutting Board Install the left end trim piece and swing-up workShown, do not push the trim piece in all Way and do not add bolts yetInstall the work surface Do not use the work surface as a cutting boardYou will need work surface Page You will need Bottom shelf Install the thermometerInstall the bottom shelf You will need ThermometerLighting To ExtinguishSummary lighting instructions are on the control panel Manual Lighting Cleaning CookingStorage Inspection and Cleaning of the Weber Spider Stopper Guards Annual MaintenanceGeneral Maintenance Main Burner Cleaning ProcedureWeber Spider Stopper Guards Replacing Main Burners Crossover Ignition System Operations Smell of gas Flame is low when burner is onBurners burn with a yellow or Orange flame, in conjunction with
Top Page Image Contents