Weber 55204 manual Burners burn with a yellow or, Orange flame, in conjunction with, Smell of gas

Page 33

Troubleshooting

Problem

Check

Cure

Burners burn with a yellow or

Inspect Weber Spider Stopper

Clean Weber Spider Stopper

orange flame, in conjunction with

Guards for possible obstructions.

Guards. (See Section “Annual

the smell of gas.

(Blockage of holes.)

Maintenance”)

 

 

 

Burner does not light, or flame is

Is fuel hose bent or kinked?

Straighten fuel hose.

low in HIGH position.

 

 

Does the Front burner light with a

If you can light the Front burner with

 

 

match?

a match, then check the Crossover

 

 

Ignition System.

 

 

 

Experiencing flare-ups:

Are you preheating barbecue in the

All burners on high for 10 to 15

 

prescribed manner?

minutes for preheating.

 

 

 

 

Are the cooking grates and

Clean thoroughly. (See Section

 

Flavorizer bars heavily coated with

“Cleaning”)

 

burned-on grease?

 

CAUTION: Do not line the

 

 

 

 

bottom tray with aluminum foil.

Is the bottom tray “dirty” and not

Clean bottom tray

 

allowing grease to flow into catch

 

 

pan?

 

 

 

 

Burner flame pattern is erratic.

Are burners clean?

Clean burners. (See Section

Flame is low when burner is on

 

“General Maintenance”.)

HIGH. Flames do not run the

 

 

whole length of the burner tube.

 

 

 

 

 

Inside of lid appears to be

The lid is porcelain-on-steel, not

Clean thoroughly. (See Section

“peeling.” (Resembles paint

paint. It cannot “peel”. What you are

“Cleaning”.)

peeling.)

seeing is baked on grease that has

 

 

turned to carbon and is flaking off.

 

 

THIS IS NOT A DEFECT.

 

 

 

 

If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your region using the contact information sheet provided with your manual

D-8

Image 33
Contents Extinguish any open flames If you smell gas Shut off gas to the applianceLiquid Propane GAS Units only Customer Service Center South Hicks RoadPalatine, IL Contents For Installation in Canada Gas Supply TestingStorage OperatingGenesis Silver-B NG Page Page Page Page Assembly Instructions Continue frame assembly Complete frame assembly Insert casters Add cooking box assembly You will need manifold bracket Install manifold bracketIgniter lock nut with an adjustable wrench or pliers Install igniterGas Catcher Ignition Chamber and the igniter. This Was done to factory test the ignition systemLeaks. Be sure there are no sparks or open Do not use an open flame to check for gasFlames in the area while you check for gas Leaks. This will result in a fire or explosionPage Representative in your region using the contact BARBECUE. Contact the Customer ServiceCheck for gas leaks Or3 turn OFF the gas. do not OperateInstall Lid Install the slide out bottom trayGrease and not allowing grease to flow into Catch panRight swing-up work surface Install the right end trim piece with tool holdersView inside of control panel Shown, do not push the trim piece in all Install the left end trim piece and swing-up workWay and do not add bolts yet Do not use the swing-up work surface as a cutting BoardInstall the work surface Do not use the work surface as a cutting boardYou will need work surface Page Install the bottom shelf Install the thermometerYou will need Thermometer You will need Bottom shelfLighting To ExtinguishSummary lighting instructions are on the control panel Manual Lighting Cleaning CookingStorage Inspection and Cleaning of the Weber Spider Stopper Guards Annual MaintenanceGeneral Maintenance Main Burner Cleaning ProcedureWeber Spider Stopper Guards Replacing Main Burners Crossover Ignition System Operations Burners burn with a yellow or Flame is low when burner is onOrange flame, in conjunction with Smell of gas