Weber 55204 manual View inside of control panel

Page 21

4.) While holding swing-up work surface in position,

5.) Add a washer to the bolt and insert it through the

insert the other end of the swing-up work surface

front hole in the frame and the hole in the trim

rod into the right end trim piece (1). Push the trim

piece. Tighten with a wrench.

piece into the frame as shown, making sure that

 

the tab on the back underside piece of the trim

 

piece is snapped into the slot in the rear frame (2).

 

View from underneath

 

(2)

 

(1)

View inside of control panel

C-2

Image 21
Contents Extinguish any open flames If you smell gas Shut off gas to the applianceLiquid Propane GAS Units only Customer Service Center South Hicks RoadPalatine, IL Contents For Installation in Canada Gas Supply TestingStorage OperatingGenesis Silver-B NG Page Page Page Page Assembly Instructions Continue frame assembly Complete frame assembly Insert casters Add cooking box assembly You will need manifold bracket Install manifold bracketIgniter lock nut with an adjustable wrench or pliers Install igniterGas Catcher Ignition Chamber and the igniter. This Was done to factory test the ignition systemLeaks. Be sure there are no sparks or open Do not use an open flame to check for gasFlames in the area while you check for gas Leaks. This will result in a fire or explosionPage Representative in your region using the contact BARBECUE. Contact the Customer ServiceCheck for gas leaks Or3 turn OFF the gas. do not OperateInstall Lid Install the slide out bottom trayGrease and not allowing grease to flow into Catch panRight swing-up work surface Install the right end trim piece with tool holdersView inside of control panel Shown, do not push the trim piece in all Install the left end trim piece and swing-up workWay and do not add bolts yet Do not use the swing-up work surface as a cutting BoardInstall the work surface Do not use the work surface as a cutting boardYou will need work surface Page Install the bottom shelf Install the thermometerYou will need Thermometer You will need Bottom shelfLighting To ExtinguishSummary lighting instructions are on the control panel Manual Lighting Cleaning CookingStorage Inspection and Cleaning of the Weber Spider Stopper Guards Annual MaintenanceGeneral Maintenance Main Burner Cleaning ProcedureWeber Spider Stopper Guards Replacing Main Burners Crossover Ignition System Operations Burners burn with a yellow or Flame is low when burner is onOrange flame, in conjunction with Smell of gas