Weber 55204 manual Manual Lighting

Page 27

Manual Lighting

DANGER

Failure to open lid while igniting the barbecue’s burners, or not waiting 5 minutes to allow the gas to clear if the barbecue does not light, may result in an explosive flame-up which can cause serious bodily injury or death.

1)Open the lid.

2)Make sure all burner control knobs are turned OFF. (Push each burner control knob down and turn clockwise to ensure they are in the off position.)

3)Turn the gas supply valve on.

4)Strike a match and put the flame into the matchlight hole in the front of the cooking box.

1

2

7

3

4,6

5

*The grill illustrated may have slight differences than the model purchased.

WARNING: Do not lean over the open barbecue. Keep your face and body at least one foot away from the matchlight hole when lighting the barbecue.

5)Push Front burner control knob down and turn to START/HI.

6)Check that the burner is lit by looking through the matchlight hole on the front of the cooking box. You should see a flame.

WARNING: If the burner does not light, turn the Front burner control knob to OFF and wait 5 minutes to let the gas clear before you try again or try to light with a match.

7)After the FRONT burner is lit you can turn on the other burner or burners.

Note - Always light the FRONT burner first. The other burner or burners ignite from the FRONT burner.

To Extinguish

Push down and turn each burner control knob clockwise to the OFF position. Turn gas supply OFF at the source.

D-2

Image 27
Contents Extinguish any open flames If you smell gas Shut off gas to the applianceLiquid Propane GAS Units only Customer Service Center South Hicks RoadPalatine, IL Contents Operating Gas Supply TestingFor Installation in Canada StorageGenesis Silver-B NG Page Page Page Page Assembly Instructions Continue frame assembly Complete frame assembly Insert casters Add cooking box assembly You will need manifold bracket Install manifold bracketWas done to factory test the ignition system Install igniterIgniter lock nut with an adjustable wrench or pliers Gas Catcher Ignition Chamber and the igniter. ThisLeaks. This will result in a fire or explosion Do not use an open flame to check for gasLeaks. Be sure there are no sparks or open Flames in the area while you check for gasPage Or3 turn OFF the gas. do not Operate BARBECUE. Contact the Customer ServiceRepresentative in your region using the contact Check for gas leaksCatch pan Install the slide out bottom trayInstall Lid Grease and not allowing grease to flow intoRight swing-up work surface Install the right end trim piece with tool holdersView inside of control panel Do not use the swing-up work surface as a cutting Board Install the left end trim piece and swing-up workShown, do not push the trim piece in all Way and do not add bolts yetInstall the work surface Do not use the work surface as a cutting boardYou will need work surface Page You will need Bottom shelf Install the thermometerInstall the bottom shelf You will need ThermometerLighting To ExtinguishSummary lighting instructions are on the control panel Manual Lighting Cleaning CookingStorage Inspection and Cleaning of the Weber Spider Stopper Guards Annual MaintenanceGeneral Maintenance Main Burner Cleaning ProcedureWeber Spider Stopper Guards Replacing Main Burners Crossover Ignition System Operations Smell of gas Flame is low when burner is onBurners burn with a yellow or Orange flame, in conjunction with