Weber 55204 manual Install manifold bracket, You will need manifold bracket

Page 14

	Your Weber Gas Grill Manifold assembly consisting of	Install manifold bracket
	gas manifold, valves and gas burners has been factory	You will need: manifold bracket.
	assembled, pressure- and flame- tested. As a safety	Hook the bracket(2) onto the manifold at the center
	precaution, we recommend you check the burner	burner valve. Place your hand underneath the bracket.
	alignment:	Lift the manifold, bracket and cooking box slightly, then
	1) Are the ends of the burners under the washers at	hook the tab of the bracket onto the frame brace(1).
	the left rear and left front of the cooking box? The	(1)	(2)
	screws are only guides. Do not tighten.		(2)
	screws are only guides. Do not tighten.

2)Do the valves fit into the ends of the burners?

3)Are the wing nuts under the burner assembly hand

tight? Do not tighten with pliers.

If you answered YES to 1, 2 and 3, the burners are

correctly aligned. If you answered NO, the burners are

misaligned. Contact the Customer Service Representative in your region using the contact information sheet provided with your manual. Do not use grill.

(2)

(1)

(3)

B-4

Image 14

Contents If you smell gas Shut off gas to the appliance Extinguish any open flamesLiquid Propane GAS Units only Palatine, IL Customer Service CenterSouth Hicks Road Contents Storage Gas Supply TestingFor Installation in Canada OperatingGenesis Silver-B NG Page Page Page Page Assembly Instructions Continue frame assembly Complete frame assembly Insert casters Add cooking box assembly Install manifold bracket You will need manifold bracketGas Catcher Ignition Chamber and the igniter. This Install igniterIgniter lock nut with an adjustable wrench or pliers Was done to factory test the ignition systemFlames in the area while you check for gas Do not use an open flame to check for gasLeaks. Be sure there are no sparks or open Leaks. This will result in a fire or explosionPage Check for gas leaks BARBECUE. Contact the Customer ServiceRepresentative in your region using the contact Or3 turn OFF the gas. do not OperateGrease and not allowing grease to flow into Install the slide out bottom trayInstall Lid Catch panInstall the right end trim piece with tool holders Right swing-up work surfaceView inside of control panel Way and do not add bolts yet Install the left end trim piece and swing-up workShown, do not push the trim piece in all Do not use the swing-up work surface as a cutting BoardYou will need work surface Install the work surfaceDo not use the work surface as a cutting board Page You will need Thermometer Install the thermometerInstall the bottom shelf You will need Bottom shelfSummary lighting instructions are on the control panel LightingTo Extinguish Manual Lighting Storage CleaningCooking Annual Maintenance Inspection and Cleaning of the Weber Spider Stopper GuardsWeber Spider Stopper Guards General MaintenanceMain Burner Cleaning Procedure Replacing Main Burners Crossover Ignition System Operations Orange flame, in conjunction with Flame is low when burner is onBurners burn with a yellow or Smell of gas