Weber 55204 manual Continue frame assembly Complete frame assembly

Page 12

Continue frame assembly	Complete frame assembly
You will need: caster frame, wheel frame, four 1/2 inch	You will need: partial frame assembly, two frame
bolts, four nylon washers and a 7/16 inch or adjustable	connectors, four 2 inch bolts, four nylon
wrench.	washers and a 7/16 inch or adjustable wrench.
Place the caster frame onto the tabs of the left frame,	Hold one frame connector between the caster frame
so that the swing table locking latch (1) is to the rear.	and wheel frame. Add the nylon washer to the bolt.
Place the wheel frame onto the tabs of the right frame,	Insert the bolt through the frame and screw into frame
so that the swing table locking latch (2) is to the rear.	connector. Tighten bolt with wrench.
The leg tabs must be on the inside of the frames.	Repeat procedure with the other frame connector.
Add the washers to the bolts. Insert the bolts into the
holes as shown, do not tighten bolts on wheel
frame until a later step.

(1)

(2)

B-2

Image 12

Contents If you smell gas Shut off gas to the appliance Extinguish any open flamesLiquid Propane GAS Units only Customer Service Center South Hicks RoadPalatine, IL Contents Gas Supply Testing For Installation in CanadaStorage OperatingGenesis Silver-B NG Page Page Page Page Assembly Instructions Continue frame assembly Complete frame assembly Insert casters Add cooking box assembly Install manifold bracket You will need manifold bracketInstall igniter Igniter lock nut with an adjustable wrench or pliersGas Catcher Ignition Chamber and the igniter. This Was done to factory test the ignition systemDo not use an open flame to check for gas Leaks. Be sure there are no sparks or openFlames in the area while you check for gas Leaks. This will result in a fire or explosionPage BARBECUE. Contact the Customer Service Representative in your region using the contactCheck for gas leaks Or3 turn OFF the gas. do not OperateInstall the slide out bottom tray Install LidGrease and not allowing grease to flow into Catch panInstall the right end trim piece with tool holders Right swing-up work surfaceView inside of control panel Install the left end trim piece and swing-up work Shown, do not push the trim piece in allWay and do not add bolts yet Do not use the swing-up work surface as a cutting BoardInstall the work surface Do not use the work surface as a cutting boardYou will need work surface Page Install the thermometer Install the bottom shelfYou will need Thermometer You will need Bottom shelfLighting To ExtinguishSummary lighting instructions are on the control panel Manual Lighting Cleaning CookingStorage Annual Maintenance Inspection and Cleaning of the Weber Spider Stopper GuardsGeneral Maintenance Main Burner Cleaning ProcedureWeber Spider Stopper Guards Replacing Main Burners Crossover Ignition System Operations Flame is low when burner is on Burners burn with a yellow orOrange flame, in conjunction with Smell of gas