Weber 55204 manual

Page 24

Install control panel and burner control knobs	Install Flavorizer® Bars and Cooking Grates
You will need: control panel, two Phillips screws/	You will need: five Flavorizer Bars and two cooking
washers, a Phillips screwdriver, and burner control	grates.
knobs.	Place the Flavorizer Bars side by side in the cooking
1) Set the control panel in place over both frame	box.
braces. Hold the Crossover Ignition button up
while setting the control panel in place.

2)While looking under the right trim piece push the control panel down and line up the holes in the control panel with the white plastic plugs in the frame brace. Insert screws and tighten with a

phillips screw driver until snug. Do not over

tighten.

3) Push each of the burner control knobs onto their valve.

(1)

Set the cooking grates onto the ledges in the cooking box with the rounded sides up.

(2)

(3)

C-5

Image 24

Contents If you smell gas Shut off gas to the appliance Extinguish any open flamesLiquid Propane GAS Units only Customer Service Center South Hicks RoadPalatine, IL Contents Gas Supply Testing For Installation in CanadaStorage OperatingGenesis Silver-B NG Page Page Page Page Assembly Instructions Continue frame assembly Complete frame assembly Insert casters Add cooking box assembly Install manifold bracket You will need manifold bracketInstall igniter Igniter lock nut with an adjustable wrench or pliersGas Catcher Ignition Chamber and the igniter. This Was done to factory test the ignition systemDo not use an open flame to check for gas Leaks. Be sure there are no sparks or openFlames in the area while you check for gas Leaks. This will result in a fire or explosionPage BARBECUE. Contact the Customer Service Representative in your region using the contactCheck for gas leaks Or3 turn OFF the gas. do not OperateInstall the slide out bottom tray Install LidGrease and not allowing grease to flow into Catch panInstall the right end trim piece with tool holders Right swing-up work surfaceView inside of control panel Install the left end trim piece and swing-up work Shown, do not push the trim piece in allWay and do not add bolts yet Do not use the swing-up work surface as a cutting BoardInstall the work surface Do not use the work surface as a cutting boardYou will need work surface Page Install the thermometer Install the bottom shelfYou will need Thermometer You will need Bottom shelfLighting To ExtinguishSummary lighting instructions are on the control panel Manual Lighting Cleaning CookingStorage Annual Maintenance Inspection and Cleaning of the Weber Spider Stopper GuardsGeneral Maintenance Main Burner Cleaning ProcedureWeber Spider Stopper Guards Replacing Main Burners Crossover Ignition System Operations Flame is low when burner is on Burners burn with a yellow orOrange flame, in conjunction with Smell of gas