Weber 55204 manual Assembly Instructions

Page 11

Assembly Instructions

Assemble wheel frame				Assemble frame
You will need: axle rod, two wheel hubcaps, two				You will need: left frame, right frame, two 1/2 inch
wheels, wheel frame, hammer and a block of wood.				bolts, two nylon washers and a 7/16 inch or adjustable
Place one end of the axle rod on the block of wood (or				wrench.
other protected surface). Tap one hubcap onto the end				Note - Work on carpeted area (on grass or one of the
of the axle rod. Slide one wheel onto the axle, WEBER				boxes) to protect the finish during frame assembly.
name facing out. Next, slide the other end of the axle				Lay the leg frame pieces as shown so the leg tabs
rod through the wheel frame. Add the other wheel,				point up.
WEBER name side facing out. Tap the hubcap onto				1) Connect the two frame pieces with the tabs inside
the axle rod to complete the axle.				of the frame.
				2) Slip washers on bolts, then insert bolts as shown
EB	R	W		and tighten. (If you try to insert a bolt and there is
W			E
		R	B	no hole, you have the left frame turned the wrong
				no hole, you have the left frame turned the wrong
				way. Turn the left frame around.)
				(1)

(2)

B067.b

B-1

Image 11

Contents Extinguish any open flames If you smell gas Shut off gas to the applianceLiquid Propane GAS Units only Palatine, IL Customer Service CenterSouth Hicks Road Contents Operating Gas Supply TestingFor Installation in Canada StorageGenesis Silver-B NG Page Page Page Page Assembly Instructions Continue frame assembly Complete frame assembly Insert casters Add cooking box assembly You will need manifold bracket Install manifold bracketWas done to factory test the ignition system Install igniterIgniter lock nut with an adjustable wrench or pliers Gas Catcher Ignition Chamber and the igniter. ThisLeaks. This will result in a fire or explosion Do not use an open flame to check for gasLeaks. Be sure there are no sparks or open Flames in the area while you check for gasPage Or3 turn OFF the gas. do not Operate BARBECUE. Contact the Customer ServiceRepresentative in your region using the contact Check for gas leaksCatch pan Install the slide out bottom trayInstall Lid Grease and not allowing grease to flow intoRight swing-up work surface Install the right end trim piece with tool holdersView inside of control panel Do not use the swing-up work surface as a cutting Board Install the left end trim piece and swing-up workShown, do not push the trim piece in all Way and do not add bolts yetYou will need work surface Install the work surfaceDo not use the work surface as a cutting board Page You will need Bottom shelf Install the thermometerInstall the bottom shelf You will need ThermometerSummary lighting instructions are on the control panel LightingTo Extinguish Manual Lighting Storage CleaningCooking Inspection and Cleaning of the Weber Spider Stopper Guards Annual MaintenanceWeber Spider Stopper Guards General MaintenanceMain Burner Cleaning Procedure Replacing Main Burners Crossover Ignition System Operations Smell of gas Flame is low when burner is onBurners burn with a yellow or Orange flame, in conjunction with