Portable Trace Oxygen Analyzer | Operation |
|
|
At any time you can press the ESC key to abort the entry and return to the DATE screen.
3.2.5 STANDARD ALARM Screen
Note: Alarm relays are not included on the standard version of the 3110.
During an alarm a blinking “AL” will appear in the upper right corner of the display. Use the UP/DOWN keys to navigate to the STANDARD ALARM screen. This screen displays the alarm setpoint on the lower line. You can change the setpoint and on this screen.
To change the alarm setpoint or toggle between ppm and %:
1.Press ENTER to enter the alarm setup function. Note the navigation arrows that appear on the left and right sides of the display change from UP/DOWN to LEFT/RIGHT
2.Use the UP/DOWN keys to alter the value in the setpoint field. Then press ENTER to accept this new value. The cursor will move over to the next editable field.
3.Use the UP/DOWN keys to toggle between PPM or % then press ENTER to accept the change.
4.Press ENTER again to save the setpoint changes and return to the STANDARD ALARM screen.
3.2.6ALARM Enable
The next four screens determine the characteristics of the alarm: whether it is on or off, failsafe or
From the ALARM ENABLE screen you can set whether the alarm is on or off.
Teledyne Analytical Instruments | 29 |