Invacare TerminatorTM SS Adjusting TOE IN/TOE OUT, Camber Tube 2000 Figure, A4 Camber System

SECTION 5 WHEELS

ADJUSTING TOE IN/TOE OUT

CAMBER TUBE 2000 (FIGURE 10)

WHEELS

1.Open the camber clamps. Refer to OPENING/CLOSING CLAMPS in this section of the manual.

2.Slowly rotate the camber tube in either direction until the rear wheels are approximately in a straight line.

3.Close the camber clamps. Refer to OPENING/CLOSING CLAMPS in this section of the manual.

Camber Tube - Rotates Up and Down

Camber Clamps

FIGURE 10 - ADJUSTING TOE IN/ TOE OUT - CAMBER BAR 2000

4.Measure the distance between the center lines at the rear and front of the rear wheels at approximately 12-inches from the ground/floor. Refer to DETERMINING TOE IN/TOE OUT in this section of the manual.

5.Repeat STEPS 1-4 until the toe in/toe out measurement is less than 1/2-inch (0 + 1/4-inch for maximum rollability).

A4 CAMBER SYSTEM

Course Adjustment (FIGURE 11).

NOTE: This procedure is required any time the axle tube is moved from the factory set position or is replaced.

NOTE: Make the following adjustment for one (1) camber at a time.

1.Open the camber clamps. Refer to OPENING/CLOSING CLAMPS in this section of the manual.

2.Loosen the phillips screws that secure the adjustment rings to the axle tube.

3.Slowly rotate the axle tube until the rear wheels are approximately in a straight line.

WARNING

QUICK RELEASE LEVERS - Make sure the quick release levers are pointing towards the rear of the wheelchair and are in the CLOSED position BEFORE using the wheelchair, otherwise personal injury or damage to the wheelchair may result.

WARNING

STANDARD - Make sure the hex screws and locknuts are securely tightened BEFORE using the wheelchair, otherwise personal injury or damage to the wheelchair may result.

4.Close the camber clamp. Refer to OPENING/CLOSING CLAMPS in this section of the manual.

Terminator™ SS 34 Part No. 1052712 Rev D