Invacare TerminatorTM SS manual Installing QUAD-RELEASE Axles Figure, And/Or Out

SECTION 5 WHEELS

INSTALLING QUAD-RELEASE AXLES (FIGURE 3)

1.Remove rear wheel and the existing quick-release axle from the wheelchair. Refer to REMOVING/INSTALLING REAR WHEELS in this section of the manual.

2.Remove existing quick-release axle from rear wheel.

WHEELS

3.Insert new quad-release axle through rear wheel hub.

4.Slide locking collar onto quad-release axle until it is snug against rear wheel and tighten securely with allen screw.

5.Reinstall rear wheel and the quad- release axle onto the wheelchair. Refer to REMOVING/INSTALLING REAR WHEELS in this section of the manual.

6.Flip the handle of the quad-release axle down to release the detent pin ensuring that the locking pins are fully released.

Quad	Allen Screw	Adjustable Axle
		Position Camber
Release			Bar
Axle
			Locking
	Rear Wheel Hub		Collar

NOTE: End of Quad Release axle shown for reference only. It is not visible when inserted into camber bar

FIGURE 3 - INSTALLING QUAD-

RELEASE AXLES

7.If detent pin does not fully release, proceed to ADJUSTING QUAD-RELEASE HANDLE IN AND/OR OUT in this section of the manual.

8.Repeat STEPS 1-7 for the opposite rear wheel.

ADJUSTING QUAD-RELEASE HANDLES (FIGURE 4)

IN AND/OR OUT

1.Remove rear wheel and the quad- release axle from the wheelchair. Refer to REMOVING/INSTALLING REAR WHEELS in this section of the manual.

2.Loosen the locking screw.

3.Make the following adjustments:

If the quad-release handle is not releasing the locking pins completely, rotate the quad-release handle approximately one-quarter (1/4) turn

CLOCKWISE.

If the quad-release handle hits the spokes of the rear wheel when assembled, rotate the quad-release handle approximately one-quarter (1/4) turn

COUNTERCLOCKWISE.

ADJUSTING

QUAD-RELEASE

HANDLE IN/AND Locking Pins

OR OUT

Quad Release
Handle	Camber Bar

Locking

Screw

REMOVING
PLAY FROM		Length
REAR	Adjusting Locknut
		Adjustment
WHEELS	(on Quick-Release
		Screw
	Axle)

FIGURE 4 - ADJUSTING QUAD-

RELEASE HANDLES

Terminator™ SS 28 Part No. 1052712 Rev D