WHEELS | SECTION 5 |
|
|
REPLACING AXLE TUBE (FIGURE 16)
NOTE: The camber bar is always mounted to the BOTTOM of the wheelchair frame.
NOTE: There is no need to remove the two (2) camber clamps when replacing the axle tube.
1.A4 CAMBER SYSTEM ONLY - Note the position of the camber inserts so they can be installed at the same position in the new axle tube.
2.Open the camber clamps. Refer to OPENING/CLOSING CLAMPS in this section of the manual.
3.Remove the (2) rear wheels. Refer to REMOVING/INSTALLING REAR WHEELS in this section of the manual.
4.A4 CAMBER SYSTEM ONLY - Remove the camber inserts positioned in the axle tube.
5.A4 CAMBER SYSTEM ONLY - Loosen, but do not remove the two (2) phillips screws that secure the toe adjustment rings to the axle tube.
WHEELS
A4 CAMBER
SYSTEM
Notch in 
Axle Tube
Camber Clamp
Camber Insert
Indexing
Ring
FRONT OF
WHEELCHAIR
Camber
Clamp
REAR OF |
| Slot in Axle Tube |
|
WHEELCHAIR |
| ||
|
| ||
Toe Adjustment |
|
|
|
Ring |
|
| Camber Insert |
|
|
| |
|
| Set Screw |
|
| Axle Tube | CAMBER | |
|
|
| |
Toe Adjustment Ring | TUBE 2000 | ||
| |||
REAR OF
WHEELCHAIRAxle
Tube
Set Screw
FRONT OF
WHEELCHAIR
FIGURE 16 - REPLACING AXLE TUBE
Part No. 1052712 Rev D | 39 | Terminator™ SS |