Invacare TerminatorTM SS manual Procedure Suspension, Detail C Axle Tube Positions

SUSPENSION

PROCEDURE 7 SUSPENSION

13.Install the rear wheels into the camber inserts. Refer to REMOVING/INSTALLING REAR WHEELS in PROCEDURE 5 of this manual.

14.Adjust the axle tube. Refer to ADJUSTING THE AXLE TUBE in PROCEDURE 5 of this manual.

NOTE: The performance of the wheelchair will be affected if the axle tube has not been adjusted to correct the toe in/toe out of the wheelchair.

15.Ensure the camber clamps are closed. Refer to OPENING/CLOSING CLAMPS in PROCEDURE 5 of the manual.

16.Adjust anti-tippers. Refer to ANTI-TIPPER REPLACEMENT/ADJUSTMENT in PROCEDURE 6 of the manual.

NOTE: QUICK RELEASE LEVERS ONLY - Reposition the quick release levers to the top/bottom of the axle tube if desired. Refer to REPOSITIONING QUICK RELEASE LEVERS in this procedure of the manual.

Camber	Axle Tube
Clamp

Locknuts

Camber

InsertSuspension

Tube

Hex Bolt

NOTE: LEFT camber clamp and suspension tube not shown for clarity.

DETAIL "A" - CLAMP POSITION

NOTE: Axle tubes are viewed from the FRONT of the wheelchair.

NOTE: Socket facing DOWN not shown for clarity.

STANDARD CLAMP POSITION -

TABS/SOCKETS

Camber	Axle	Tab DOWN
Clamps	Tubes

DETAIL "C" - AXLE TUBE POSITIONS

AXLE SUSPENSION CLAMP CLAMP POSITION TUBE HOLE HOLE POSITION*

TOP	A	1	STANDARD
Suspension	B	2	Camber
			Clamp
Tube
			Tab DOWN
MIDDLE	B	1	STANDARD
Suspension	C	2	Camber
Tube			Clamp
			Tab DOWN
BOTTOM	A	2	INVERTED
	B	1
Suspension			Tab UP
Tube			Camber
			Clamp

NOTE: Tabs on camber clamps shown. Anti-tipper sockets are not shown for clarity.

NOTE: When viewed from the front of the wheelchair, inside of the rear wheels, an inverted camber clamp has the tab or anti-tipper socket at the top of the axle tube. Refer to DETAIL "A".

	Socket DOWN	DETAIL "B" - MOUNTING HOLE
INVERTED CLAMP POSITION - TABS/			PATTERN
				Suspension Tube
	Socket UP		Hole A
			Hole B
Camber Clamps	Axle Tubes	Hole 1	Hole C
		Hole 2
	Tab UP
				Camber Clamp
		Tab
				Metal Tabs

FIGURE 5 - REPOSITIONING THE AXLE TUBE

Terminator™ SS 56 Part No. 1052712 Rev D