SECTION 6 | |
|
|
INSTALLING/ADJUSTING OPTIONAL CLAMP ON RAISED FOOTREST (FIGURE 2)
INSTALLING
1.Install the two (2) half clamps onto either side of the wheelchair frame approximately
2.Repeat for the opposite side of the wheelchair.
3.Slide the clamp on raised footrest into the half clamps to the desired height.
4.Securely tighten the four (4) allen screws.
Wheelchair Frame |
| |
Half Clamp | Allen | |
| Screws | |
Raised | Outside | |
Footrest | ||
Footrest | ||
Hoop | ||
|
FIGURE 2 - INSTALLING/
ADJUSTING OPTIONAL CLAMP
ON RAISED FOOTREST
FOOTREST / ANTI-TIPPER
ADJUSTING
1.Loosen the four (4) allen screws.
2.Adjust clamp on raised footrest to the desired height.
3.Securely tighten all four (4) allen screws.
INSTALLING/ADJUSTING OPTIONAL A4 FOOTREST (FIGURE 3)
REPLACING THE FOOTREST
1.Loosen, but do not remove the two (2) allen screws that secure the footrest to the wheelchair frame.
2.Slide the EXISTING footrest tubes out of the wheelchair frame and install NEW footrest by reversing this step.
3.Position the NEW footrest to a determined height.
4.Tighten the two (2) allen screws that secure the footrest to the wheelchair frame.
5.Adjust the footplate to the desired position. Refer to FOOTPLATE ANGLE ADJUSTMENT and/or FOOTPLATE DEPTH ADJUSTMENT in this section of the manual.
FOOTPLATE ANGLE ADJUSTMENT
1.Loosen, but do not remove the four (4) flat screws and locknuts that secure the footplate to the two (2) footrest tubes.
2.Position the footplate to the necessary angle to accommodate the user.
3.Retighten the four (4) flat screws and locknuts.
NOTE: The locknuts should be placed in the channel of the footplate half clamp.
Part No. 1052712 Rev D | 47 | Terminator™ SS |