SECTION
SECTION 5—MAINTENANCE AND TROUBLESHOOTING
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure that all attaching hardware is tightened securely - otherwise, injury or damage may occur.
Before performing any maintenance, adjustment or service, turn power OFF and remove key from ignition.
DO NOT overtighten hardware attaching to the frame. This could cause damage to the frame.
When storing scooter for prolonged periods of time, remove batteries. Refer to Removing/Installing the Batteries on 300 on page 50 OR Removing/Installing the Batteries on 400 on page 53. After reinstallation, always recharge batteries before use. Refer to Charging the Batteries on page 58.
Use care in storage. DO NOT allow any metallic objects to contact the exposed ter- minals.
SUGGESTED MAINTENANCE PROCEDURES
1.Before using the powered scooter, make sure all nuts and bolts are tight. Check any parts for damage or wear and replace. Check all parts for proper adjustment.
2.Ensure that batteries are properly maintained and charged as required.
3.The wheels and tires should be checked periodically for cracks and wear, and should be replaced by a qualified technician.
4.Regularly check for loose nuts and/or bolts in the front and drive wheels. If loose, have them adjusted by a qualified technician.
5.Clean dirt, dust and grease from exposed components.
6.Periodically have the bearings of the front wheel checked to make sure they are clean and free from moisture.
LUBRICATION POINTS
NOTE: For this procedure, refer to FIGURE 5.1.
1.Every six (6) months, lubricate the top of the seat post using a Teflon lubricant.
Seat Post
(TOP)
Seat
Part No. 1118395 | 25 | 300 and 400 |