SECTION 11—WHEELS AND CASTERS
REMOVING/INSTALLING THE FRONT WHEEL
NOTE: Take note of position and orientation of wheel and mounting hardware before removing.
NOTE: For this procedure, refer to FIGURE 11.2.
REMOVING
1.Turn power OFF and remove the key from the ignition.
2.Place the FRONT of the powered scooter UP on blocks so that the FRONT wheel is off the ground.
3.Remove the mounting screw, locknut and two (2) spacers that secure the FRONT wheel to the fork.
4. Remove FRONT wheel from fork.
Fork
Upper Fork Mounting
Hole for 400
Lower Fork Mounting
Hole for 300
Spacer
Locknut
Mounting Screw
Spacer
Front Wheel
FIGURE 11.2 - REMOVING/INSTALLING THE FRONT WHEEL
INSTALLING
WARNING
Front wheel MUST be mounted in the correct fork mounting holes (upper mount- ing holes for the 400 and lower mounting holes for 300) - otherwise injury may result.
1.Perform one (1) of the following -
A.On 300 - Align front wheel with the lower fork mounting holes.
B.On 400 - Align front wheel with the upper fork mounting holes.
2.Using the mounting screw, locknut and two (2) spacers that secure the front wheel to the fork
3.Securely tighten front wheel mounting hardware.
Part No. 1118395 | 47 | 300 and 400 |