Invacare HMV Highly 300, HMV Highly 400 manual Replacing Armrest Pads, Adjusting ARM Height

Page 42

SECTION 8—ARMS

3.Reinstall the lock knob that secures the arm to the arm mounting tube and tighten securely.

4.Repeat STEPS 1-3 for opposite arm, if necessary.

Lock Knob

Arm

Arm Mounting Tube

FIGURE 8.3 - ADJUSTING ARM HEIGHT

REPLACING ARMREST PADS

NOTE: For this procedure, refer to FIGURE 8.4.

1.Remove the two (2) mounting screws that secures the armrest pad to arm.

2.Remove the old armrest pad.

3.Install new armrest pad and securely tighten with existing mounting screws.

4.If necessary, repeat STEPS 1-3 to replace the other armrest pad.

Arm Pad

Arm

Mounting Screws

FIGURE 8.4 - REPLACING ARMREST PADS

300 and 400

42

Part No. 1118395

Image 42

Contents HMVHighly Maneuverable Vehicle 300 Table of Contents Arms Tiller AdjustmentSeat Rear ShroudScooter Accessories BatteriesTransporting Register Your Product Register Your ProductProduct Registration Form Fold here Cut Along Line Special Notes TIE-DOWN Restraints and Seat RestraintsSeat Positioning Strap Typical Product Parameters 300 400Label Locations Front Frame Assembly Repair or Service Information General GuidelinesOperation Information General Guidelines Tire Pressure ElectricalRain Test Weight TrainingBatteries Grounding InstructionsWeight Limitation EMI Information EMI InformationEMI Information SAFETY/HANDLING of Powered Scooters Percentage of Weight DistributionStability and Balance Stairways EscalatorsSafety Inspection Safety Inspection ChecklistsINSPECT/ADJUST Initially INSPECT/ADJUST Weekly INSPECT/ADJUST MonthlyINSPECT/ADJUST Every SIX 6 Months INSPECT/ADJUST Periodically Maintenance and Troubleshooting Suggested Maintenance ProceduresLubrication Points Troubleshooting Symptom Probable Cause SolutionOperation of the Powered Scooter Control PanelNumber Fault Impact on Control PanelOperation of the Powered Scooter Number Fault Impact on Control Panel Horn and Throttle Control LeverOperating the Scooter Brake Release Lever Resetting the Circuit Breaker Brake Release LeverReplacing the Fuse Replacing the FuseSeat REMOVING/INSTALLING the SeatInstalling RemovingREMOVING/INSTALLING the Seat Post REMOVING/INSTALLING the Seat PostAdjusting Seat Height Adjusting Seat DepthSeat Swivel Adjustment Adjusting Seat DepthREMOVING/INSTALLING Seat Positioning Strap 90 Seat Swivel AdjustmentREMOVING/INSTALLING Seat Positioning Strap Adjusting ARM Width REMOVING/INSTALLING/ADJUSTING ArmsREMOVING/INSTALLING ArmsAdjusting ARM Angle Adjusting ARM HeightAdjusting ARM Height Replacing Armrest PadsTiller Adjustment Adjusting the Tiller AngleREMOVING/INSTALLING the Rear Shroud Rear ShroudREMOVING/INSTALLING the Drive Wheels Wheels and CastersREMOVING/INSTALLING the Drive Wheels REMOVING/INSTALLING the Front Wheel REMOVING/INSTALLING the Front WheelREMOVING/INSTALLING the Caster Assemblies REMOVING/INSTALLING the Caster AssembliesBatteries Recommended Battery Type REMOVING/INSTALLING the Batteries onRemoving REMOVING/INSTALLING the Batteries on REMOVING/INSTALLING the Batteries on Built-in Lifting Straps CONNECTING/DISCONNECTING the Battery Cables on ConnectingDisconnecting CONNECTING/DISCONNECTING the Battery Cables on ON-BOARD Battery Charger Charging the BatteriesBattery Charger Operation Charger Indicator Light on Tiller Charging Indicator StatusDisassembling TransportingTransporting the Scooter Assembling400 Transporting Right Scooter Accessories REMOVING/INSTALLING the Front BasketINSTALLING/REMOVING the CRUTCH/CANE Holder INSTALLING/REMOVING the CRUTCH/CANE HolderINSTALLING/REMOVING the Safety Flag INSTALLING/REMOVING/USING the Walker HolderInstallation Warnings INSTALLING/REMOVING the Walker Holder Using the Walker HolderINSTALLING/REMOVING the Rear Mounted Basket INSTALLING/REMOVING the Rear Mounted Basket300 300 Limited Warranty Limited WarrantyUSA