Invacare HMV Highly 400, HMV Highly 300 manual REMOVING/INSTALLING the Batteries on

Page 53

SECTION 12—BATTERIES

REMOVING/INSTALLING THE BATTERIES ON 400

NOTE: For this procedure, refer to FIGURE 12.2.

REMOVING

1.Place the powered scooter in a well ventilated area where work can be performed without risking damage to carpeting or floor covering.

2.Turn power OFF and remove the key from the ignition.

3.Remove the seat. Refer to Removing/Installing the Seat on page 34.

4.Remove the rear shroud. Refer to Removing/Installing the Rear Shroud on page 44.

5.Disconnect the two (2) Black battery connectors from the wiring harness connectors.

6.Pull the hook and loop fastening battery strap apart.

7.Perform one (1) of the following to remove the battery from the battery tray:

A.BATTERIES WITH BUILT-IN LIFTING STRAP - Use built in lifting strap to remove the battery from the battery tray.

B.BATTERIES WITHOUT BUILT-IN LIFTING STRAP - Use a battery lifting strap to remove the battery from the battery tray.

INSTALLING

1.Place the powered scooter in a well ventilated area where work can be performed without risking damage to carpeting or floor covering.

2.Turn power OFF and remove the key from the ignition.

3.Remove the seat. Refer to Removing/Installing the Seat on page 34.

4.Remove the rear shroud. Refer to Removing/Installing the Rear Shroud on page 44.

5.Perform one (1) of the following to position the battery into the battery tray:

A.BATTERIES WITH BUILT-IN LIFTING STRAP - Use built in lifting strap to position battery onto the battery tray.

B.BATTERIES WITHOUT BUILT-IN LIFTING STRAP - Use a battery lifting strap to position battery onto battery tray. When battery is in proper position, remove lifting strap.

6.Connect the two (2) BLACK battery connectors to the wiring harness connectors.

7.Secure batteries in the battery tray using the battery strap.

8.Reinstall the rear shroud. Refer to Removing/Installing the Rear Shroud on page 44.

9.Reinstall the seat. Refer to Removing/Installing the Seat on page 34.

NOTE: New batteries MUST be fully charged BEFORE using, otherwise the life of the batteries will be reduced.

10. If necessary, charge the batteries. Refer to Charging the Batteries on page 58.

Part No. 1118395

53

300 and 400

Image 53

Contents HMVHighly Maneuverable Vehicle 300 Table of Contents Seat Tiller AdjustmentArms Rear ShroudTransporting Scooter AccessoriesBatteries Register Your Product Register Your ProductProduct Registration Form Fold here Cut Along Line Seat Positioning Strap Special NotesTIE-DOWN Restraints and Seat Restraints 300 400 Typical Product ParametersLabel Locations Front Frame Assembly Operation Information Repair or Service InformationGeneral Guidelines General Guidelines Electrical Tire PressureBatteries Weight TrainingRain Test Grounding InstructionsWeight Limitation EMI Information EMI InformationEMI Information Stability and Balance SAFETY/HANDLING of Powered ScootersPercentage of Weight Distribution Escalators StairwaysINSPECT/ADJUST Initially Safety InspectionSafety Inspection Checklists INSPECT/ADJUST Every SIX 6 Months INSPECT/ADJUST WeeklyINSPECT/ADJUST Monthly INSPECT/ADJUST Periodically Lubrication Points Maintenance and TroubleshootingSuggested Maintenance Procedures Symptom Probable Cause Solution TroubleshootingControl Panel Operation of the Powered ScooterControl Panel Number Fault Impact onControl Panel Horn and Throttle Control Lever Operation of the Powered Scooter Number Fault Impact onOperating the Scooter Brake Release Lever Brake Release Lever Resetting the Circuit BreakerReplacing the Fuse Replacing the FuseInstalling REMOVING/INSTALLING the SeatSeat RemovingREMOVING/INSTALLING the Seat Post REMOVING/INSTALLING the Seat PostAdjusting Seat Depth Adjusting Seat HeightAdjusting Seat Depth Seat Swivel Adjustment90 Seat Swivel Adjustment REMOVING/INSTALLING Seat Positioning StrapREMOVING/INSTALLING Seat Positioning Strap REMOVING/INSTALLING REMOVING/INSTALLING/ADJUSTING ArmsAdjusting ARM Width ArmsAdjusting ARM Height Adjusting ARM AngleReplacing Armrest Pads Adjusting ARM HeightAdjusting the Tiller Angle Tiller AdjustmentRear Shroud REMOVING/INSTALLING the Rear ShroudWheels and Casters REMOVING/INSTALLING the Drive WheelsREMOVING/INSTALLING the Drive Wheels REMOVING/INSTALLING the Front Wheel REMOVING/INSTALLING the Front WheelREMOVING/INSTALLING the Caster Assemblies REMOVING/INSTALLING the Caster AssembliesBatteries REMOVING/INSTALLING the Batteries on Recommended Battery TypeRemoving REMOVING/INSTALLING the Batteries on REMOVING/INSTALLING the Batteries on Built-in Lifting Straps Connecting CONNECTING/DISCONNECTING the Battery Cables onDisconnecting CONNECTING/DISCONNECTING the Battery Cables on Charging the Batteries ON-BOARD Battery ChargerCharging Indicator Status Battery Charger Operation Charger Indicator Light on TillerTransporting the Scooter TransportingDisassembling Assembling400 Transporting Right REMOVING/INSTALLING the Front Basket Scooter AccessoriesINSTALLING/REMOVING the CRUTCH/CANE Holder INSTALLING/REMOVING the CRUTCH/CANE HolderInstallation Warnings INSTALLING/REMOVING the Safety FlagINSTALLING/REMOVING/USING the Walker Holder Using the Walker Holder INSTALLING/REMOVING the Walker HolderINSTALLING/REMOVING the Rear Mounted Basket INSTALLING/REMOVING the Rear Mounted Basket300 300 Limited Warranty Limited WarrantyUSA