Invacare HMV Highly 300, HMV Highly 400 manual Control Panel, Number Fault Impact on

SECTION 6—OPERATION OF THE POWERED SCOOTER

	DETAIL “A” - 300
	Battery Charge
Status	Indicator LED
	On/Off Key
Indicator LED
	Switch

Horn	Speed	Charging
		Indicator LED
	Control Knob

	DETAIL “B” - 400
	Status		Battery Charge
Headlight	Indicator LED		Indicator LED
Switch			On/Off Key
		BATTERY LEVEL		Switch
			OFF
	STATUS		CHARGING

ON

Horn	Speed	Charging
	Control Knob	Indicator LED

FIGURE 6.1 - CONTROL PANEL

3.CHARGING INDICATOR - Located on the TOP face of the control panel as shown in FIGURE 6.1. Solid RED indicates the charger is on (plugged into wall receptacle).

4.STATUS INDICATOR - Located on the TOP face of the control panel as shown in FIGURE 6.1. Status LED will flash intermittently, separated by a pause, to provide diagnostic information. Refer to the following table.

NUMBER	FAULT	IMPACT ON	NOTES
OF FLASHES		SCOOTER
1	Battery needs	Will Drive	Battery charge is running low. Recharge the
	recharging.		batteries as soon as possible.
2	Battery voltage	Drive Inhibited	Battery charge is empty. Recharge the batter-
	too low.		ies. If the scooter is left off for a few minutes,
			battery charge may recover sufficiently to
			allow driving for a short period of time.
3	Battery voltage	Drive Inhibited	Battery charge is too high. Scooter will charge
	too high.		batteries when traveling down slopes or
			decelerating. Excessive charging in this man-
			ner may cause this fault. Turn the scooter
			power off and then back on again.
4	Current limit	Drive Inhibited	The scooter has drawn too much current for
	time-out.		too long, possibly because the motor has
			been over-worked, jammed or stalled. Turn
			the scooter power off and then turn back on
			again after a few minutes.
5	Brake fault.	Drive Inhibited	Check that the brake release lever is in the
			engaged position. The park brake coil or wir-
			ing is faulty. Check the park brake and wiring
			for open or short circuit.

300 and 400 28 Part No. 1118395