Invacare HMV Highly 300, HMV Highly 400 manual EMI Information

Page 18

SECTION 2—EMI INFORMATION

SECTION 2—EMI INFORMATION

WARNING

CAUTION: IT IS VERY IMPORTANT THAT YOU READ THIS INFORMATION REGARDING THE POSSIBLE EFFECTS OF ELECTROMAGNETIC INTERFERENCE ON YOUR POWERED WHEELCHAIR.

Electromagnetic Interference (EMI) From Radio Wave Sources

Powered wheelchairs and motorized scooters (in this text, both will be referred to as powered wheelchairs) may be susceptible to electromagnetic interference (EMI), which is interfering electromagnetic energy (EM) emitted from sources such as radio stations, TV stations, amateur radio (HAM) transmitters, two way radios, and cellular phones. The interference (from radio wave sources) can cause the powered wheelchair to release its brakes, move by itself, or move in unintended directions. It can also permanently damage the powered wheelchair's control system. The intensity of the interfering EM energy can be measured in volts per meter (V/m). Each powered wheelchair can resist EMI up to a certain intensity. This is called its "immunity level." The higher the immunity level, the greater the protection. At this time, current technology is capable of achieving at least a 20 V/m immunity level, which would provide useful protection from the more common sources of radiated EMI.

There are a number of sources of relatively intense electromagnetic fields in the everyday environment. Some of these sources are obvious and easy to avoid. Others are not apparent and exposure is unavoidable. However, we believe that by following the warnings listed below, your risk to EMI will be minimized.

The sources of radiated EMI can be broadly classified into three types:

1)Hand-held Portable transceivers (transmitters-receivers with the antenna mounted directly on the transmitting unit. Examples include: citizens band (CB) radios, "walkie talkie", security, fire and police transceivers, cellular telephones, and other personal communication devices).

NOTE: Some cellular telephones and similar devices transmit signals while they are ON, even when not being used.

2)Medium-range mobile transceivers, such as those used in police cars, fire trucks, ambulances and taxis. These usually have the antenna mounted on the outside of the vehicle; and

3)Long-range transmitters and transceivers, such as commercial broadcast transmitters (radio and TV broadcast antenna towers) and amateur (HAM) radios.

NOTE: Other types of hand-held devices, such as cordless phones, laptop computers, AM/FM radios, TV sets, CD players, cassette players, and small appliances, such as elec- tric shavers and hair dryers, so far as we know, are not likely to cause EMI problems to your powered wheelchair.

300 and 400

18

Part No. 1118395

Image 18
Contents HMVHighly Maneuverable Vehicle 300 Table of Contents Arms Tiller AdjustmentSeat Rear ShroudScooter Accessories BatteriesTransporting Register Your Product Register Your ProductProduct Registration Form Fold here Cut Along Line Special Notes TIE-DOWN Restraints and Seat RestraintsSeat Positioning Strap Typical Product Parameters 300 400Label Locations Front Frame Assembly Repair or Service Information General GuidelinesOperation Information General Guidelines Tire Pressure ElectricalRain Test Weight TrainingBatteries Grounding InstructionsWeight Limitation EMI Information EMI InformationEMI Information SAFETY/HANDLING of Powered Scooters Percentage of Weight DistributionStability and Balance Stairways EscalatorsSafety Inspection Safety Inspection ChecklistsINSPECT/ADJUST Initially INSPECT/ADJUST Weekly INSPECT/ADJUST MonthlyINSPECT/ADJUST Every SIX 6 Months INSPECT/ADJUST Periodically Maintenance and Troubleshooting Suggested Maintenance ProceduresLubrication Points Troubleshooting Symptom Probable Cause SolutionOperation of the Powered Scooter Control PanelNumber Fault Impact on Control PanelOperation of the Powered Scooter Number Fault Impact on Control Panel Horn and Throttle Control LeverOperating the Scooter Brake Release Lever Resetting the Circuit Breaker Brake Release LeverReplacing the Fuse Replacing the FuseSeat REMOVING/INSTALLING the SeatInstalling RemovingREMOVING/INSTALLING the Seat Post REMOVING/INSTALLING the Seat PostAdjusting Seat Height Adjusting Seat DepthSeat Swivel Adjustment Adjusting Seat DepthREMOVING/INSTALLING Seat Positioning Strap 90 Seat Swivel AdjustmentREMOVING/INSTALLING Seat Positioning Strap Adjusting ARM Width REMOVING/INSTALLING/ADJUSTING ArmsREMOVING/INSTALLING ArmsAdjusting ARM Angle Adjusting ARM HeightAdjusting ARM Height Replacing Armrest PadsTiller Adjustment Adjusting the Tiller AngleREMOVING/INSTALLING the Rear Shroud Rear ShroudREMOVING/INSTALLING the Drive Wheels Wheels and CastersREMOVING/INSTALLING the Drive Wheels REMOVING/INSTALLING the Front Wheel REMOVING/INSTALLING the Front WheelREMOVING/INSTALLING the Caster Assemblies REMOVING/INSTALLING the Caster AssembliesBatteries Recommended Battery Type REMOVING/INSTALLING the Batteries onRemoving REMOVING/INSTALLING the Batteries on REMOVING/INSTALLING the Batteries on Built-in Lifting Straps CONNECTING/DISCONNECTING the Battery Cables on ConnectingDisconnecting CONNECTING/DISCONNECTING the Battery Cables on ON-BOARD Battery Charger Charging the BatteriesBattery Charger Operation Charger Indicator Light on Tiller Charging Indicator StatusDisassembling TransportingTransporting the Scooter Assembling400 Transporting Right Scooter Accessories REMOVING/INSTALLING the Front BasketINSTALLING/REMOVING the CRUTCH/CANE Holder INSTALLING/REMOVING the CRUTCH/CANE HolderINSTALLING/REMOVING the Safety Flag INSTALLING/REMOVING/USING the Walker HolderInstallation Warnings INSTALLING/REMOVING the Walker Holder Using the Walker HolderINSTALLING/REMOVING the Rear Mounted Basket INSTALLING/REMOVING the Rear Mounted Basket300 300 Limited Warranty Limited WarrantyUSA