SECTION 7—SEAT
REMOVING/INSTALLING THE SEAT POST
WARNING
Ensure that the seat post mounting screw is properly engaged and locked. Other- wise, injury and/or damage may result.
NOTE: Take note of position and orientation of the seat post and seat post mounting screw before removing.
NOTE: The seat post has three (3) height settings. If a change in seat height is desired refer to adjusting seat height in this section of the manual.
NOTE: For this procedure, refer to FIGURE 7.2.
REMOVING
1.If necessary, remove the seat. Refer to Removing/Installing the Seat on page 34.
2.Remove the mounting screw, two (2) washers and locknut securing the seat post to the frame post (FIGURE 7.2).
3.Lift seat post UP and remove from frame post.
INSTALLING
1.Insert the seat post into the frame post and align the frame post mounting hole with the desired seat post mounting hole. Refer to FIGURE 7.2.
2.Insert mounting screw through both the frame post and the seat post. Install the two
(2) washers and locknut onto mounting screw and securely tighten.
3.If necessary, install the seat. Refer to Removing/Installing the Seat on page 34.
Seat Post
Washer
Mounting Screw
Frame Post
Mounting Screw
Seat Post
Mounting Holes
Locknut
Washer
NOTE: Seat post on 300 shown. Seat post on 400 installs the same way.
FIGURE 7.2 - REMOVING/INSTALLING THE SEAT POST
Part No. 1118395 | 35 | 300 and 400 |