Invacare HMV Highly 400, HMV Highly 300 manual INSPECT/ADJUST Weekly, INSPECT/ADJUST Monthly

Page 23

SECTION 4—SAFETY INSPECTION

Tighten locknut if the front wheel wobbles noticeably or loosen locknut if the wheel binds to a stop.

Ensure that the fork stem bearing set is tight.

Ensure that wheel bearings are clean and free of moisture.

Ensure that the bolts and fasteners on the caster assemblies are tight.

Inspect caster assembly for proper tension by spinning the caster. The caster should come to a gradual stop.

Inspect tires for flat spots and wear.

Clean molded body shrouds.

INSPECT/ADJUST WEEKLY

Ensure that tiller adjustment lever engages and disengages properly and securely.

Ensure that the scooter stops completely when throttle is released (i.e., does not continue to roll as if the throttle is activated).

Inspect tires for flat spots and wear.

INSPECT/ADJUST MONTHLY

Check brake for binding or interference with travel.

Inspect front wheel/fork assembly for proper tension by spinning the wheel. The front wheel should come to a gradual stop.

Tighten locknut if the front wheel wobbles noticeably or loosen locknut if the wheel binds to a stop.

Ensure that the fork stem bearing set is tight.

Inspect seat swivel for release and engagement (seat locks into the determined swivel positions).

Inspect the seat positioning strap for signs of wear. Replace if worn or damaged.

Ensure that the buckle on the seat positioning strap latches. Replace if necessary.

Verify that the hardware that attaches the seat positioning strap to the seat frame is secure and undamaged. Replace if necessary.

Ensure that the bolts and fasteners on the caster assemblies are tight.

Inspect caster assembly for proper tension by spinning the caster. The caster should come to a gradual stop.

INSPECT/ADJUST EVERY SIX (6) MONTHS

Lubricate the top of the seat using a Teflon®lubricant.

Part No. 1118395

23

300 and 400

Image 23
Contents HMVHighly Maneuverable Vehicle 300 Table of Contents Rear Shroud Tiller AdjustmentSeat ArmsTransporting Scooter AccessoriesBatteries Register Your Product Register Your ProductProduct Registration Form Fold here Cut Along Line Seat Positioning Strap Special NotesTIE-DOWN Restraints and Seat Restraints 300 400 Typical Product ParametersLabel Locations Front Frame Assembly Operation Information Repair or Service InformationGeneral Guidelines General Guidelines Electrical Tire PressureGrounding Instructions Weight TrainingBatteries Rain TestWeight Limitation EMI Information EMI InformationEMI Information Stability and Balance SAFETY/HANDLING of Powered ScootersPercentage of Weight Distribution Escalators StairwaysINSPECT/ADJUST Initially Safety InspectionSafety Inspection Checklists INSPECT/ADJUST Every SIX 6 Months INSPECT/ADJUST WeeklyINSPECT/ADJUST Monthly INSPECT/ADJUST Periodically Lubrication Points Maintenance and TroubleshootingSuggested Maintenance Procedures Symptom Probable Cause Solution TroubleshootingControl Panel Operation of the Powered ScooterControl Panel Number Fault Impact onControl Panel Horn and Throttle Control Lever Operation of the Powered Scooter Number Fault Impact onOperating the Scooter Brake Release Lever Brake Release Lever Resetting the Circuit BreakerReplacing the Fuse Replacing the FuseRemoving REMOVING/INSTALLING the SeatInstalling SeatREMOVING/INSTALLING the Seat Post REMOVING/INSTALLING the Seat PostAdjusting Seat Depth Adjusting Seat HeightAdjusting Seat Depth Seat Swivel Adjustment90 Seat Swivel Adjustment REMOVING/INSTALLING Seat Positioning StrapREMOVING/INSTALLING Seat Positioning Strap Arms REMOVING/INSTALLING/ADJUSTING ArmsREMOVING/INSTALLING Adjusting ARM WidthAdjusting ARM Height Adjusting ARM AngleReplacing Armrest Pads Adjusting ARM HeightAdjusting the Tiller Angle Tiller AdjustmentRear Shroud REMOVING/INSTALLING the Rear ShroudWheels and Casters REMOVING/INSTALLING the Drive WheelsREMOVING/INSTALLING the Drive Wheels REMOVING/INSTALLING the Front Wheel REMOVING/INSTALLING the Front WheelREMOVING/INSTALLING the Caster Assemblies REMOVING/INSTALLING the Caster AssembliesBatteries REMOVING/INSTALLING the Batteries on Recommended Battery TypeRemoving REMOVING/INSTALLING the Batteries on REMOVING/INSTALLING the Batteries on Built-in Lifting Straps Connecting CONNECTING/DISCONNECTING the Battery Cables onDisconnecting CONNECTING/DISCONNECTING the Battery Cables on Charging the Batteries ON-BOARD Battery ChargerCharging Indicator Status Battery Charger Operation Charger Indicator Light on TillerAssembling TransportingTransporting the Scooter Disassembling400 Transporting Right REMOVING/INSTALLING the Front Basket Scooter AccessoriesINSTALLING/REMOVING the CRUTCH/CANE Holder INSTALLING/REMOVING the CRUTCH/CANE HolderInstallation Warnings INSTALLING/REMOVING the Safety FlagINSTALLING/REMOVING/USING the Walker Holder Using the Walker Holder INSTALLING/REMOVING the Walker HolderINSTALLING/REMOVING the Rear Mounted Basket INSTALLING/REMOVING the Rear Mounted Basket300 300 Limited Warranty Limited WarrantyUSA