Invacare HMV Highly 400, HMV Highly 300 manual Brake Release Lever

Page 31

SECTION 6—OPERATION OF THE POWERED SCOOTER

NOTE: Throttle control levers operate such that moving one (1) will also move the opposite side throttle control lever.

7.To operate the scooter, depress the throttle control lever in the following manner:

A.TO MOVE FORWARD - Push the RIGHT side throttle control lever FORWARD (away from user) or pull the LEFT side throttle control lever REARWARD (towards user).

B.TO MOVE IN REVERSE - Push the LEFT side throttle control lever FORWARD (away from user) or pull the RIGHT side throttle control lever REARWARD (towards user).

C.TO STOP - Release the throttle control lever and the powered scooter will quickly slow down and the brake will engage.

NOTE: To equip the scooter for LEFT hand operation, contact a qualified technician.

The powered scooter is equipped with a "proportional" control meaning that the farther you depress the throttle control lever, the faster the powered scooter travels. With a proportional control, you can drive as slowly in the high speed setting as you can in the low speed setting. Your top speed, however, is limited by the setting of the speed-control knob. For safety reasons, reverse speed is limited to approximately 50% of forward speed.

When first learning to drive, adjust speed control knob for a SLOW speed and try to drive the powered scooter AS SLOWLY as possible by depressing the throttle control lever only slightly. This exercise will help you learn to utilize the full potential of the proportional control and allow you to start and stop smoothly.

BRAKE RELEASE LEVER

WARNING

Ensure that the brake-release lever is in the ENGAGED position before driving. There should be an audible "click" when stopping and starting.

NOTE: For the following information, refer to FIGURE 6.3.

The brake release lever manually engages and disengages the brake. The brake release lever is located under the shroud near the LEFT caster assembly.

The brake MUST be ENGAGED (lever pushed IN) in normal driving conditions. Activation of the throttle control lever automatically releases the brake so that the powered scooter can drive. Releasing the throttle control lever automatically engages the brake so as to prevent the powered scooter from rolling on its own.

When the brake release lever is DISENGAGED (lever pulled OUT) and the key is removed, the powered scooter can be pushed. The powered scooter CANNOT be driven with the brake in the DISENGAGED (lever pulled OUT) position.

Part No. 1118395

31

300 and 400

Page 30 Page 32
Image 31
Page 30 Page 32
Contents HMVHighly Maneuverable Vehicle 300 Table of Contents Rear Shroud Tiller AdjustmentSeat ArmsBatteries Scooter AccessoriesTransporting Register Your Product Register Your ProductProduct Registration Form Fold here Cut Along Line TIE-DOWN Restraints and Seat Restraints Special NotesSeat Positioning Strap 300 400 Typical Product ParametersLabel Locations Front Frame Assembly General Guidelines Repair or Service InformationOperation Information General Guidelines Electrical Tire PressureGrounding Instructions Weight TrainingBatteries Rain TestWeight Limitation EMI Information EMI InformationEMI Information Percentage of Weight Distribution SAFETY/HANDLING of Powered ScootersStability and Balance Escalators StairwaysSafety Inspection Checklists Safety InspectionINSPECT/ADJUST Initially INSPECT/ADJUST Monthly INSPECT/ADJUST WeeklyINSPECT/ADJUST Every SIX 6 Months INSPECT/ADJUST Periodically Suggested Maintenance Procedures Maintenance and TroubleshootingLubrication Points Symptom Probable Cause Solution TroubleshootingControl Panel Operation of the Powered ScooterControl Panel Number Fault Impact onControl Panel Horn and Throttle Control Lever Operation of the Powered Scooter Number Fault Impact onOperating the Scooter Brake Release Lever Brake Release Lever Resetting the Circuit BreakerReplacing the Fuse Replacing the FuseRemoving REMOVING/INSTALLING the SeatInstalling SeatREMOVING/INSTALLING the Seat Post REMOVING/INSTALLING the Seat PostAdjusting Seat Depth Adjusting Seat HeightAdjusting Seat Depth Seat Swivel Adjustment90 Seat Swivel Adjustment REMOVING/INSTALLING Seat Positioning StrapREMOVING/INSTALLING Seat Positioning Strap Arms REMOVING/INSTALLING/ADJUSTING ArmsREMOVING/INSTALLING Adjusting ARM WidthAdjusting ARM Height Adjusting ARM AngleReplacing Armrest Pads Adjusting ARM HeightAdjusting the Tiller Angle Tiller AdjustmentRear Shroud REMOVING/INSTALLING the Rear ShroudWheels and Casters REMOVING/INSTALLING the Drive WheelsREMOVING/INSTALLING the Drive Wheels REMOVING/INSTALLING the Front Wheel REMOVING/INSTALLING the Front WheelREMOVING/INSTALLING the Caster Assemblies REMOVING/INSTALLING the Caster AssembliesBatteries REMOVING/INSTALLING the Batteries on Recommended Battery TypeRemoving REMOVING/INSTALLING the Batteries on REMOVING/INSTALLING the Batteries on Built-in Lifting Straps Connecting CONNECTING/DISCONNECTING the Battery Cables onDisconnecting CONNECTING/DISCONNECTING the Battery Cables on Charging the Batteries ON-BOARD Battery ChargerCharging Indicator Status Battery Charger Operation Charger Indicator Light on TillerAssembling TransportingTransporting the Scooter Disassembling400 Transporting Right REMOVING/INSTALLING the Front Basket Scooter AccessoriesINSTALLING/REMOVING the CRUTCH/CANE Holder INSTALLING/REMOVING the CRUTCH/CANE HolderINSTALLING/REMOVING/USING the Walker Holder INSTALLING/REMOVING the Safety FlagInstallation Warnings Using the Walker Holder INSTALLING/REMOVING the Walker HolderINSTALLING/REMOVING the Rear Mounted Basket INSTALLING/REMOVING the Rear Mounted Basket300 300 Limited Warranty Limited WarrantyUSA
Top Page Image Contents