Invacare 1073955 manual Replacing the T-Arm Locking Lever

SECTION 6—ARMS

4.Re‐secure the side guard to the bottom clamp with the two bottom mounting screws. Securely tighten.

5.Install the T‐arm onto the wheelchair. Refer to Installing/Removing the T‐arms on page 42.

Side

Guard

T-Arm

Transfer

Assist

Bottom Mounting

Screws (STEPS 2,4)

Bottom Clamp (STEPS 2,4)

FIGURE 6.7 Adjusting the Transfer Assists and/or Side Guards

Replacing the T-Arm Locking Lever

NOTE: For this procedure, refer to FIGURE 6.8 on page 48.

1.Remove the T‐arm from the wheelchair. Refer to Installing/Removing the T‐arms on page 42.

2.Remove the phillips bolt and locknut that secure the existing locking lever to the bottom bracket.

NOTE: The locking lever is spring loaded. Place your free hand over the locking lever to prevent the parts from springing off of the bottom bracket.

3. Remove the existing locking lever and spring from the bottom bracket. NOTE: Inspect the spring for wear and damage. Replace if necessary.

4.Position the spring on the bottom bracket as shown in FIGURE 6.8.

5.Position the new locking lever onto the spring and the bottom bracket.

NOTE: Make sure the two extended ends of the spring are inside the notch in the locking lever. 6. Line up the mounting holes in the new locking lever, spring and bottom bracket.

Part No. 1073955 47 Orbit™